Fox2506
06-27-2012, 03:07 PM
Leftover parts after a Stage II crate engine swap (and of course NO fuel distributor). All parts in good condition, though a little dirty:
Intake manifold w/ cold start tube & plug wire bracket
Mixture control unit (early style with brass o-ring retainer for idle tube)
bullhorn pipe
throttle assy. (one broken idle screw)
throttle gasket (attached to throttle)
throttle rod
distributor (no cap, tach wire is fine)
Oil pan
Valley Y-pipe w/ sensors
heater pipe (a little nasty of course)
Flywheel
oil fill cap
Steering knuckle, upper and lower (replaced for SS upgrade)
water pump - rebuildable
If anyone is interested, I'll start posting pics. I didn't post prices but I have it worked out, I'll haggle. *Saving up for new LCA's and LCA braces. Located in NC.
Intake manifold w/ cold start tube & plug wire bracket
Mixture control unit (early style with brass o-ring retainer for idle tube)
bullhorn pipe
throttle assy. (one broken idle screw)
throttle gasket (attached to throttle)
throttle rod
distributor (no cap, tach wire is fine)
Oil pan
Valley Y-pipe w/ sensors
heater pipe (a little nasty of course)
Flywheel
oil fill cap
Steering knuckle, upper and lower (replaced for SS upgrade)
water pump - rebuildable
If anyone is interested, I'll start posting pics. I didn't post prices but I have it worked out, I'll haggle. *Saving up for new LCA's and LCA braces. Located in NC.