Can anyone ID this gasket?

[kings1527]

This is from under the metal plate held in place with two 10mm bolts on the W-pipe; the one with the wire retaining clip. Mine is pretty beat up and I'm looking to replace it, but it's not on the parts list. A part number or where I can get one would be great.

Thanks!

11839

Alex
6575

[1batt4u]

I had same problem! I was told to use Right Stuff Gasket Maker!!

[jawn101]

+1 on Right Stuff there, that's not a common service point so there's no reason not to permanently seal it.

[Delorean Industries]

Available in stainless from Delorean Performance in our original stainless section and comes with a new gasket.
https://www.deloreanindustries.com/shop/originalstainless/air-horn-cross-over-ss.html

[David T]

You certainly can goop it up with some silicone sealer. Making a small gasket like that is very easy. Go to an auto store and buy a piece of thin gasket materiel. You can use a scissors, Exacto knife, or you can beat it out using a small ball peen hammer.
David Teitelbaum