mluder
07-23-2012, 02:43 PM
In the process of replacing my clutch slave cylinder I found that the rubber boot over the clutch fork http://store.delorean.com/p-8456-boot-clutch-fork.aspx was torn away from the rivets that hold it in place. I have sourced a new boot but have no idea how I'm going to attach it.
I don't think I can drill out the old rivets because the pieces inside the transmission will drop down into the clutch and that seems like a bad idea.
I thought about using a washer and small screw through the hole in the rivet and hoping it stays together.
Any one have any ideas or run into this?
Cheers
Steve
I don't think I can drill out the old rivets because the pieces inside the transmission will drop down into the clutch and that seems like a bad idea.
I thought about using a washer and small screw through the hole in the rivet and hoping it stays together.
Any one have any ideas or run into this?
Cheers
Steve