ltemup4650
07-23-2012, 04:22 PM
Hello fellow DMCers,
I have a lot of engine parts for sale. Most of these came off of a running motor with bad cylinder liners. I replaced the motor with a B28F out of a volvo and have a lot of extra parts.
I live in Bloomington, IL
You can contact me at: [email protected]
Prices I believe are fair (25% to 75% below new) and most are negotiable.
Block (upper crankcase-cylinder liners removed) Part #:102001 $400
Crankshaft (will come with timing and oil pump sprockets. Will need machined/turned) $300
Crankshaft pulley nut. Part #:102474 $10
Pistons and connecting rods (6) (NOTE: pistons are probably NOT good, but the connecting rods are). $50 each connecting rod (will come with a piston)
Head (rebuilt, only 200 miles. Off running motor) 4,5,6 (loaded with valves) Part #:102157 $400
Head (rebuilt, only 200 miles. Off running motor) 1,2,3 (loaded with valves) Part #:102173 $400
Cam Shaft 1,2,3 (Passenger) Part #:102707 $100
Cam Shaft 4,5,6 (Driver) Part #:102706 $100
Rocker Arm Assembly (1,2,3) $150
Rocker Arm Assembly (4,5,6) $150
Timing Chain 1,2,3 Part #:102214 $10
Timing Chain 4,5,6 Part #:102214 $10
Timing Sprocket 1,2,3 Part #: 102209 $20
Timing Sprocket 4,5,6 Part #: 102209 $20
Timing chain tensioner kit 1,2,3 Part #:102605 $75
Timing chain tensioner kit 4,5,6 Part #:102605 $75
Oil pump and sprocket Part #:102622 $100
Oil pump drive chain Part #:102229 $30
Driver side valve cover Part #:102252 $75
Timing cover Part #:102192 $100
Intake Part #:102260 $200
Tubes, throttle/manifold (Bull horns) Part #:102279 $150
Mixture control unit Part #:102789 $200
Mixture control lower housing Part #:102771 -- (NOTE, This unit has a modification where the idle air motor tube goes. It is probably a better than stock design, but still not stock. It has a welded nipple so you can slide the air hose right on. I can take a picture if you want). $75
Throttle Butterfly assembly Part #:102856 $40
Fuel Distributor Part #:102807 $200
Ignition distributor Part #:102751 -- (some of the plastic on the plug is gone, but it still plugs in and works. It came off a running motor). $150
Idle air motor (untested) Part #:102502 $100
Fuel injectors (I have 12) Part #:102742 $25 each
Cold start tube Part #:102374 $40
Cold Start Injector Part #:102372 $50
Rear main seal housing. Part #:102023 $30
Warm up regulator (untested) Part #:102353 $60
Exhuast Manifold 1,2,3 Part #:102258 $150
Exhaust Manifold 4,5,6 Part #:102257 $150
I have a lot of engine parts for sale. Most of these came off of a running motor with bad cylinder liners. I replaced the motor with a B28F out of a volvo and have a lot of extra parts.
I live in Bloomington, IL
You can contact me at: [email protected]
Prices I believe are fair (25% to 75% below new) and most are negotiable.
Block (upper crankcase-cylinder liners removed) Part #:102001 $400
Crankshaft (will come with timing and oil pump sprockets. Will need machined/turned) $300
Crankshaft pulley nut. Part #:102474 $10
Pistons and connecting rods (6) (NOTE: pistons are probably NOT good, but the connecting rods are). $50 each connecting rod (will come with a piston)
Head (rebuilt, only 200 miles. Off running motor) 4,5,6 (loaded with valves) Part #:102157 $400
Head (rebuilt, only 200 miles. Off running motor) 1,2,3 (loaded with valves) Part #:102173 $400
Cam Shaft 1,2,3 (Passenger) Part #:102707 $100
Cam Shaft 4,5,6 (Driver) Part #:102706 $100
Rocker Arm Assembly (1,2,3) $150
Rocker Arm Assembly (4,5,6) $150
Timing Chain 1,2,3 Part #:102214 $10
Timing Chain 4,5,6 Part #:102214 $10
Timing Sprocket 1,2,3 Part #: 102209 $20
Timing Sprocket 4,5,6 Part #: 102209 $20
Timing chain tensioner kit 1,2,3 Part #:102605 $75
Timing chain tensioner kit 4,5,6 Part #:102605 $75
Oil pump and sprocket Part #:102622 $100
Oil pump drive chain Part #:102229 $30
Driver side valve cover Part #:102252 $75
Timing cover Part #:102192 $100
Intake Part #:102260 $200
Tubes, throttle/manifold (Bull horns) Part #:102279 $150
Mixture control unit Part #:102789 $200
Mixture control lower housing Part #:102771 -- (NOTE, This unit has a modification where the idle air motor tube goes. It is probably a better than stock design, but still not stock. It has a welded nipple so you can slide the air hose right on. I can take a picture if you want). $75
Throttle Butterfly assembly Part #:102856 $40
Fuel Distributor Part #:102807 $200
Ignition distributor Part #:102751 -- (some of the plastic on the plug is gone, but it still plugs in and works. It came off a running motor). $150
Idle air motor (untested) Part #:102502 $100
Fuel injectors (I have 12) Part #:102742 $25 each
Cold start tube Part #:102374 $40
Cold Start Injector Part #:102372 $50
Rear main seal housing. Part #:102023 $30
Warm up regulator (untested) Part #:102353 $60
Exhuast Manifold 1,2,3 Part #:102258 $150
Exhaust Manifold 4,5,6 Part #:102257 $150