PDA

View Full Version : Diamond Select Flux - How to reverse flow of lights?



DavidProehl
07-29-2012, 06:40 PM
I picked up the latest version (gen 3) of the Diamond Select Fluxes, and just like the first gen models, the 3rd gen flashes from the inside out rather than outside in. I know there was a mod for the 1st gen to reverse the direction of the lights, something about swapping some wires running from the switch, but I haven't been able to find any details. Anyone here done the mod and could offer some insight on which wires need to be relocated? Below is a look at the wiring.

12204

Thanks in advance!

Oliver Holler
07-30-2012, 12:13 AM
I simply swapped the wires on the ends. (Un-soldered the 3 wires at the outermost tips of the 'Y', and re-soldiered them at the innermost points of the 'Y'.) And vice versa.

DavidProehl
07-30-2012, 12:20 PM
Thanks for the tip, but I'm not sure I fully understand. Are you talking about an arrangement like what I've drawn up below where the wires connect to the opposite soldering points, with it terminating on the inner most "white circle" rather than the outer most?

12225