Complete Column with Steering Wheel

[jmast]

126321263312634

$250

No Keys

Local pickup preferred but willing to ship at buyers expense.

[Jonathan]

Hi there,

Is there anyway you could take a picture from the side, showing the side where the key goes? I am interested in the canopy around the ignition and specifically the trim piece which shows the "I II III" on it.

How far away from Detroit are you if I went for a little drive from Ontario?

Thanks.

[jmast]

Sorry guys, need to sell this complete

Do not want to part out.

Detroit is a 2.5 hr drive for me from Cleveland Ohio

[Jonathan]

I didn't say I wanted to part it out. I said I wanted to see it from the side so I can decide whether I'm willing to pay $250 for an NLA $0.50 piece of plastic trim. If your column has the trim ring, I would consider buying the assembly to get that trim piece, and then figure out what to do with the rest.

[jmast]

I didn't say I wanted to part it out. I said I wanted to see it from the side so I can decide whether I'm willing to pay $250 for an NLA $0.50 piece of plastic trim. If your column has the trim ring, I would consider buying the assembly to get that trim piece, and then figure out what to do with the rest.

http://www.tacomaworld.com/gallery/data/500/medium/DSCN4343.JPG
http://www.tacomaworld.com/gallery/data/500/medium/DSCN43472.JPG

Also, PM sent
JBM

[OverlandMan]

I didn't say I wanted to part it out. I said I wanted to see it from the side so I can decide whether I'm willing to pay $250 for an NLA $0.50 piece of plastic trim. If your column has the trim ring, I would consider buying the assembly to get that trim piece, and then figure out what to do with the rest.

If you buy it I'd be interested in the steering wheel

[D Knight]

The wheel is bent. You may be able to straighten it though.