View Full Version : Mid-engine cars
opethmike
09-10-2012, 01:55 PM
This thought popped to mind this morning - can anyone think of a mid-engine car where the engine is in the actual middle of the car?
For example, my Lotus Elise is mid-engine, but the engine is barely in front of the rear wheels.
talons
09-10-2012, 02:05 PM
The Esprit is I believe, as is the Pantera.
protodelorean
09-10-2012, 02:08 PM
NHRA Funny Car:
13123
That's about as "in the middle" as you're gonna get! :burnout:
opethmike
09-10-2012, 02:09 PM
No they aren't, by what I mean by my question. If you look at either one of those cars, there is more car in front of the engine than there is behind it.
What I mean/am looking for is a car where if you drew a vertical line precisely down the middle of it, you would be drawing the line through the engine.
This was meant for Talons's reply; I hadn't seen Proto's when I wrote this.
Jacko
09-10-2012, 02:27 PM
What about modern Corvettes? Isn't the engine set far enough back to be considered 'mid-engine' albeit from the other end? Of course not far enough back to be truly 'in the middle'.:thumbup:
opethmike
09-10-2012, 02:41 PM
What about modern Corvettes? Isn't the engine set far enough back to be considered 'mid-engine' albeit from the other end? Of course not far enough back to be truly 'in the middle'.:thumbup:
Yeah, that's what I am looking for - truly in the middle.
Kenny_Z
09-10-2012, 04:46 PM
Twin-Mill
http://image.streetrodderweb.com/f/8715992/0307sr_milestones02_z.jpgp
Not one but two engines, take the transmission into account and these engines are directly in the center of the car. :tongue_stick:
As for actual production cars, you may be looking for something very obscure. I remember one from a My Classic Car episode that had an engine dead center. It was one of those really tiny cars that opened like refrigerators.
Rich W
09-10-2012, 05:00 PM
Twin-Mill
http://image.streetrodderweb.com/f/8715992/0307sr_milestones02_z.jpgp
Not one but two engines, take the transmission into account and these engines are directly in the center of the car. :tongue_stick:
As for actual production cars, you may be looking for something very obscure. I remember one from a My Classic Car episode that had an engine dead center. It was one of those really tiny cars that opened like refrigerators.
I guess the middle of the vehicle would need to be clarified as either the middle of the wheelbase or the measured middle.
Although not classified as "street vehicle", there are a few off-road vehicles that can be included in this designation,
including some long-travel, sand-rail type dune buggies, as well as some of the later model racing monster trucks.
There are some significant advantages to locating the engine near the middle of the vehicle or middle of the wheelbase,
especially when one of the primary operational functions of the vehicle is to make jumps, over and over again.
Later,
Rich W.
opethmike
09-10-2012, 07:06 PM
That car is f'ing cool. I'm not looking for production only, I'm just curious about if "true" mid-engine exists; whether production, or race, or one-off custom, what have you.
Rich brings up a good point, whether in regard to wheel base or measured middle.
This brought to mind an interesting set of mid-engine cars - The Ferrari 308 & 328. In those cars, the engine is ON TOP of the transmission, and uses a series of drive gears to connect the two together. The puts the engine up rather high, but does move more weight toward the middle of the car. Wonder if any other cars have used the engine on top of transmission configuration?
Dangermouse
09-10-2012, 08:20 PM
Catherham 7 engine must be close to the middle as the seats are over the rear axle.
Wonder if any other cars have used the engine on top of transmission configuration?Pretty much every single FWD compact I have ever come across has this configuration as far as I'm aware. The engine is directly over the front wheels, and there's a linkage that connects it to the transmission directly below it, itself linked to the wheels. I'm sure there's exceptions, but my '01 Honda Civic, '95 Oldsmobile Achieva, '11 Ford Focus, and '0? Chevy Cobalt all had it set up this way. Seems to preserve front-to-back space required in the engine compartment -- my Civic's engine compartment in particular is one cubit front-to-back, i.e from my elbow to my fingertip (I'm 5' 8" for reference). Smallest one I have yet to come across.
DashEight
09-11-2012, 02:00 AM
Google up a 1965 Cheetah racecar. I believe that as close as you can get to exactly between the wheels.
DMCVegas
09-11-2012, 11:33 AM
Correct me if I'm wrong about this, but Mid-Engine seems to describe a configuration where the engine is contained within the wheelbase of a vehicle, but the engine is located BEHIND the passengers.
Mid-Ship is where the engine is contained within the wheelbase of a vehicle, but the engine is located IN FRONT of the passengers.
opethmike
09-11-2012, 02:36 PM
Correct me if I'm wrong about this, but Mid-Engine seems to describe a configuration where the engine is contained within the wheelbase of a vehicle, but the engine is located BEHIND the passengers.
Mid-Ship is where the engine is contained within the wheelbase of a vehicle, but the engine is located IN FRONT of the passengers.
Not so sure on this one. I've never seen/heard mid-ship used to describe that second configuration, but have in numerous publications read the terms 'front mid-engine' and 'rear mid-engine'.
DMCVegas
09-11-2012, 08:15 PM
Not so sure on this one. I've never seen/heard mid-ship used to describe that second configuration, but have in numerous publications read the terms 'front mid-engine' and 'rear mid-engine'.
The Mazda RX8 was billed as midship because of the engine being behind the front wheels. Perhaps that was just more of a marketing term however.
opethmike
09-11-2012, 08:48 PM
The Mazda RX8 was billed as midship because of the engine being behind the front wheels. Perhaps that was just more of a marketing term however.
Could be; don't recall that, but I never paid much attention to the RX8.
Nicholas R
09-12-2012, 01:42 AM
The pontiac fiero engine is pretty clearly forward of the rear axle. You can actually drop the engine cradle, transmission, and engine out the bottom of the car. Thats pretty much required to do a clutch job.
Mike C.
09-12-2012, 07:23 AM
Correct me if I'm wrong about this, but Mid-Engine seems to describe a configuration where the engine is contained within the wheelbase of a vehicle, but the engine is located BEHIND the passengers.
Mid-Ship is where the engine is contained within the wheelbase of a vehicle, but the engine is located IN FRONT of the passengers.
Mid engine HAS to be in the rear of the car. Yes, they have started scooting front engines back closer to passenger compartments, but those are not true mid-engine cars. The term mid engine has always referred to a rear engine in front of the rear axle. The most popular car i can think of with this layout would be the DeTomaso Pantera and the Mangusta. I was surprised no one posted those up yet.
http://bringatrailer.com/wp-content/uploads/2009/03/1972_De_Tomaso_Pantera_For_Sale_Engine_1.jpg
Wikipedia has an article calling for Front mid engine/ RWD to be classified as FMR, but since there are no set characteristics, the cars all get shuffled back into FR (front engine, rwd). I don't put too much stock in Wikipedia, because of the public access to editing, and on this particular article, there are no sources quoted. It was all hearsay. But, if you google 'What is a mid engine car' to get a definition, I found the following:
http://www.adtsea.org/adtsea/ADTSEA%20Documents%20Pages/Comparison%20of%20Engine%20Placement.html?ArticleI D=f64057b7-2929-45ce-8914-1b78cad28efc
So, i'm going to stick by what i've known to be a mid-engine car. Pop the hood, look at the rear axle, and see if the engine sits in front of or behind it.
To talk about midship car, I went to see if I could find an article on one of the GTR's, because that definition fit perfectly since it's embossed on the car, even though technically it's not truly midship.
http://blogs.insideline.com/roadtests/2009/06/2009-nissan-gt-r-midship-bullship.html
Victor
09-12-2012, 02:25 PM
I've owned a 1991 mr2, white (Toyota). I have used it in snow (because my winter car broke down at the time) and it is a terrific drive! I even put my cross country ski on a rack on top. The interior is doll to look at and feel but the drive is very good.
I wish i could try a Lotus Esprit 1992...
Dangermouse
09-12-2012, 02:51 PM
Pic of the 7:
http://www.classicautomobiles-co.com/big_img/lotus_7.jpg
maybe more mid-ships that mid engined
DashEight
09-13-2012, 12:57 AM
http://i185.photobucket.com/albums/x35/helipilot16/1965-Cheetah-Bill-Thomas-BTM-001-Ra.jpg
Cheetah 1965
DashEight
09-13-2012, 01:50 AM
http://i80.photobucket.com/albums/j200/AE86Silver/_KGrHqN_lME_HZbdy_nBP_ghk_lIg_60_1.jpg
I forgot to note the Cheetah has doors similar to the Mercedes 300sl and another car from the 80's that was featured in a movie with Michael J Fox.
I think the Cheetah has the engine one third of the way from the front, two-thirds from the back (based on the air filter). Not really the middle.
As Rich W said, pretty much every single modern monster truck I've seen has the engine exactly in the middle (note: D-Rex is vintage, thus not modern). It used to be in the front a few decades ago, but they have since integrated it into the frame, partially because it's entirely protected by the frame (preventing damage and thus fire), and partially because it is in the gravitational center of the car, both front-to-back and top-to-bottom.
DashEight
09-13-2012, 11:43 PM
I think the Cheetah has the engine one third of the way from the front, two-thirds from the back (based on the air filter). Not really the middle.
As Rich W said, pretty much every single modern monster truck I've seen has the engine exactly in the middle (note: D-Rex is vintage, thus not modern). It used to be in the front a few decades ago, but they have since integrated it into the frame, partially because it's entirely protected by the frame (preventing damage and thus fire), and partially because it is in the gravitational center of the car, both front-to-back and top-to-bottom.
http://i80.photobucket.com/albums/j200/AE86Silver/Chettah.jpg
If you measure from spindle to spindle, you'll find the two rear cylinders are on the centerline. If the engine was back 6-7 inches, it would be dead center.
If you measure from spindle to spindle, you'll find the two rear cylinders are on the centerline. If the engine was back 6-7 inches, it would be dead center.
Maybe it's the angle of the camera, but the air filter seems to be positioned a bit differently on that one. The red Cheetah had the air filter about a foot and a half from the windshield, but the blue one looks like roughly four inches from the windshield.
007008
09-14-2012, 12:25 AM
mid-engine......kind of
http://i62.photobucket.com/albums/h93/16valvedcaddy/Picture430.jpg
DashEight
09-14-2012, 12:27 AM
I lost a bet before on the cheetahs engine place. My buddies Pops has one and i was saying my Lotus Esprits engine was closer to centerline then a front engined car. We measured and sure enough, the Cheetah's engine was closer. Only reason i had any idea.
protodelorean
09-14-2012, 09:18 AM
Keep in mind that from an engineering standpoint, there's no reason to want the engine itself in the center of the wheelbase. The goal is to have the overall vehicle's CENTER OF MASS in the center which must accommodate the DRIVER also. So the center of the wheelbase will typically end up somewhere between the driver and the engine.
NOTE: This is all assuming you're shooting for a vehicle with a 50/50 weight distribution.
Powered by vBulletin® Version 4.2.5 Copyright © 2026 vBulletin Solutions Inc. All rights reserved.