Ron
10-31-2012, 11:18 PM
I was repairing a replacement harness for someone that goes to the yellow bulkhead connector. And when I went to plug it in, I noticed there was no wire/connector in position 7 (matching the PDF bulkhead connector chart (http://dmctalk.org/showthread.php?40-All-Wiring-Schematics&p=52902&viewfull=1#post52902) that has been floating around for a long time). BUT, there was a male pin in the bulkhead connector, and, my D has both on it (ground for the Ignition by-pass relay and engine compartment light switch).
Anyone know if this is due to an auto/manual difference, early/late, (hard to believe) error in the chart or ?:hmm:?
(I added the black wire to the harness and it's good to go, but I'm wondering where the "other style" gets ground.)
Anyone know if this is due to an auto/manual difference, early/late, (hard to believe) error in the chart or ?:hmm:?
(I added the black wire to the harness and it's good to go, but I'm wondering where the "other style" gets ground.)