headlight switch

[FLYBOY]

I have the new DMCH Headlight Switch but one of the ground wires came undone so I rewired the whole thing and now it does work at all. All fuses are good, two in the realy compt. and the one 20 amp fuse on the module. Does anyone have any suggestions it doesn't click on any more?
Hazards work fine and so do turn signals.

[DMC5180]

The DMCH Headlight switch does not "CLICK" mechanically like the original. It is just a momentary switch to provide signal to the logic module. Recheck all the wires and make sure they are in the correct positions.

[FLYBOY]

The DMCH Headlight switch does not "CLICK" mechanically like the original. It is just a momentary switch to provide signal to the logic module. Recheck all the wires and make sure they are in the correct positions.

All the wires look like they are where they should be anything else to check?
there are 5 wires to the module with one black(jumped) and one red/green (jumped)
and four to the swicth. Which all seem to be correct, but clearly I did something wrong.

[Bitsyncmaster]

I've seen many people blow a trace in the unit by not removing the fuse or battery when they install or remove the switch. I think just hitting the side of the switch to ground will do it.

Open the unit and look for a burned out trace and jumper it with a soldered on wire.

[FLYBOY]

I've seen many people blow a trace in the unit by not removing the fuse or battery when they install or remove the switch. I think just hitting the side of the switch to ground will do it.

Open the unit and look for a burned out trace and jumper it with a soldered on wire.

Ill try that! and see what I find out