PDA

View Full Version : Craig radio wire harness



DMCflux
02-06-2013, 08:35 PM
Has anyone used Bobs prop shop Craig radio wire harness adapter?

DMCMW Dave
02-06-2013, 09:18 PM
Has anyone used Bobs prop shop Craig radio wire harness adapter?

It will not work with a modern radio due to the fact that it common-grounds the speakers together. It works fine with a Craig radio.

DMCflux
02-06-2013, 09:23 PM
What is the advantage of the harness then?

Ryan S.
02-06-2013, 09:29 PM
Ahhhh. That makes sense. I couldn't figure out why it has 9 connections only. Is it common for harness to go bad? I keep losing connection to front speakers. I am guessing that it's harness. Or could be wires. I am thinking about getting rid of harness and hard wire connections.



It will not work with a modern radio due to the fact that it common-grounds the speakers together. It works fine with a Craig radio.

DMCflux
02-06-2013, 09:49 PM
My Craig radio right speakers work intermittently. If i wiggle the dial I can hear them pop/scratch and sometimes they turn on. Would this harness solve that problem or is it in the Craig unit itself? (ps all 4 speakers are new)

Kenny_Z
02-06-2013, 10:33 PM
Sounds like your Craig is dying. The same thing happened to mine. I could push the faceplate to get the channel working again but if I hit a bump it'd go right back out.

Rich
02-06-2013, 11:06 PM
My Craig radio right speakers work intermittently. If i wiggle the dial I can hear them pop/scratch and sometimes they turn on.

These symptoms are consistent with a dirty potentiometer - that's what your volume control is, at least on radios of this vintage. Nothing to do with the harness, wiring or speakers since it comes and goes with the volume knob.

http://www.ehow.com/how_2302674_clean-knobs-vintage-audio-equipment.html

Do NOT attempt to clean it with anything other than contact cleaner made for electronic gear. Radio Shack or similar. You may need to remove the radio to get it to where it belongs.

DMCflux
02-07-2013, 01:07 AM
These symptoms are consistent with a dirty potentiometer - that's what your volume control is, at least on radios of this vintage. Nothing to do with the harness, wiring or speakers since it comes and goes with the volume knob.

http://www.ehow.com/how_2302674_clean-knobs-vintage-audio-equipment.html

Do NOT attempt to clean it with anything other than contact cleaner made for electronic gear. Radio Shack or similar. You may need to remove the radio to get it to where it belongs.

Thanks for the info Rich! I'm going to try this tomorrow.

DavidProehl
02-07-2013, 12:27 PM
Ahhhh. That makes sense. I couldn't figure out why it has 9 connections only. Is it common for harness to go bad? I keep losing connection to front speakers. I am guessing that it's harness. Or could be wires. I am thinking about getting rid of harness and hard wire connections.

As we discussed earlier, I've been losing a little less than 1 speaker a year on my audio system. When I bought the car they all worked, now I'm down to 1 working speaker. Haven't tried trouble shooting yet, either the radio or the harness. I love the look of my Craig, I'd hate to have to replace it. Hoping it is just wiring.

DMCflux
02-07-2013, 10:33 PM
Cleaned potentiometer today. Radio works great now!