View Full Version : Pneumatic Flapper Wheel Suggestions
sdg3205
02-23-2013, 03:51 PM
Has anyone procured said device for graining? Is the best bet buying the wheel and cylinder separately?
I've got a number of dents fixed and though the 80 grit really cleans them up nicely, the whole car will need a graining upon completion.
Cheers,
mluder
02-24-2013, 02:42 AM
A few people have bought the Wolf Head (formerly Vonnegut) wheel as I recall and had good success using an electric drill to re-grain. I guess the trick is maintaining RPMs which is why pneumatic is preferred. Search the forum here and you should find the details on how to order and what sandpaper loads to purchase. It's not cheap but it's the best way to go for the correct finish.
Cheers
Steve
GS450-Junkie
03-05-2013, 10:33 PM
Does anyone have a wolf head wheel they would like to sell? If so, this would be an excellent thread to mention it on.
Ryan King
03-05-2013, 11:05 PM
Check out this post I did -
http://dmctalk.org/showthread.php?1245-OFFICIAL-Re-graining-Stainless-Thread&highlight=regraining+stainless
David T
03-05-2013, 11:07 PM
I have a flexible drive cable with a rubber expander wheel that spins either a scotch brite belt or a sandpaper belt I purchased from Eastwood. You need at least a 1/3 HP electric motor to spin it. And preferably a variable speed controller with a foot pedal. It has the advantage you do not need a large air compressor. I am looking to sell it if you are interested.
David Teitelbaum
Powered by vBulletin® Version 4.2.5 Copyright © 2026 vBulletin Solutions Inc. All rights reserved.