Log in

View Full Version : Transmission 5-Speed Clutch not moving at all



Timebender
03-16-2013, 04:04 PM
Hi guys,
I've been considering buying a Delorean that's been sitting at my work for the lat 12 years, and before that its been sitting since 96. The car overall body, frame and interior is in pretty decent shape, so yesterday we tried to see if the engine would turn over once to make it want frozen. It did try to turn, but the back of
the car moved down, as if when you try to go but the brake is on.
The car is supposed to be in neutral, as the guys at work have been able to push it around to make room in the back lot.
So I tried the clutch and it doesn't budge, nor can I just grab the stick and move it into any gear.
Any help or ideas? I'd like to try again on Monday, but want to make sure it's in neutral.

Greg

TTait
03-16-2013, 04:23 PM
First check to see if there is any fluid in the clutch reservoir (near the gas filler).

Then see if you can tell if the slave cylinder is moving when someone is pressing on the clutch pedal - sounds like no.

After sitting that long you probably need to replace the master, slave, and clutch line.

Even without the clutch, you ought to be able to shift between gears - if not - the linkage is independent of the clutch hydraulics, that is another problem that will not be solved by fixing the first.

If you want to know if the engine is seized, first check the oil in via the dip stick - is there any, is it milky with water, contaminates in it? Check to see if there is any coolant, and what the condition of that is. I'be brought two cars back that sat for 12 years, and the basic engine block seems to do pretty well - with just a little luck it will be the least of your worries.

What ever you do, don't put power to the fuel pump until you have cleaned out the tank and flushed the fuel lines.

DMC5180
03-16-2013, 04:35 PM
You've found a car that's been sitting for at least 17 years and your trying to see if it will start without first looking into the fuel tank. BAD IDEA! You should pull the RPM relay or fuse 7. Otherwise you will be pushing who knows what into the fuel lines. If you want to see if the the engine is free to crank your better off putting a socket and breaker bar on the crank pulley nut. Unfortunately the Muffler is in the way.

Can you move the shifter side to side? Does the knob seemed to be centered fore and aft?

chris williams
03-16-2013, 04:50 PM
I'm in the middle of bring a 'D' back to life after it's been stood in a damp garage in the UK. everything on the hydraulic side of the brakes/clutch has had to be replaced. Both master cylinders and resovoirs clutch slave and flexible line, all brake calipers and flexi lines. These cars dont like having been stood around for a long time. Depending on where you are based the climate may have been a lot kinder to the car especially if your in a dry state as opposed to a cold & damp UK !! However you should be able to move the gearstick between the gears without the engine running. If the clutch pedal goes down then get someone to check if the slave cylinder above the clutch housing moves (or not). Maybe the flexiline connecting the two has split or the clutch master cylinder has failed and all the fluid has leaked possibly into the car. Please dont try and start it without checking out the inside of the fuel tank though. Attached is a pic of how bad the clutch M/C can get after being stored. This would not move at all.
17350

Timebender
03-16-2013, 06:33 PM
You've found a car that's been sitting for at least 17 years and your trying to see if it will start without first looking into the fuel tank. BAD IDEA! You should pull the RPM relay or fuse 7. Otherwise you will be pushing who knows what into the fuel lines. If you want to see if the the engine is free to crank your better off putting a socket and breaker bar on the crank pulley nut. Unfortunately the Muffler is in the way.

Can you move the shifter side to side? Does the knob seemed to be centered fore and aft?
We had disconnected the distributor- didn't know what fuse to pull to turn off the pump. The engine didn't turn really, bu t going to try again Monday and I'll make sure to do those things. As far as looking into the tank, or getting under the trunk lid is a whole other story- the release handle moves and I see the cable, but it doesn't look like they're connected.

Rich
03-16-2013, 10:00 PM
The car is supposed to be in neutral, as the guys at work have been able to push it around to make room in the back lot.
So I tried the clutch and it doesn't budge, nor can I just grab the stick and move it into any gear.
Any help or ideas? I'd like to try again on Monday, but want to make sure it's in neutral.

Forget the clutch for now. If the brakes are free and the car can be pushed forward or backward then you should be able to get the drivetrain to a fully unloaded position with the car in gear. Locked brakes mean you have to move the crankshaft back to unload the tranny.

Then find a way to get the gearshift to move the transmission to neutral, maybe at random times while buddies shove the car back and forth. The clutch does not need to be depressed to pop it into neutral and there is no gearshift interlock.

At least trying this method will give you some funny stories in a few years.

Follow all the other advice about next steps to resurrecting a long-dormant car.

TTait
03-17-2013, 12:19 AM
the release handle moves and I see the cable, but it doesn't look like they're connected.I assume you mean the cable is not attached to the release lever...

No big deal, just pull the cable gently with pliers while an assistant pushes down with medium force on the top center of the hood to unload any tension on the latch, once you have pulled the cable have them lift the lid open. Put a thick rag over the latch once its open so it does not lock again until you lube the latch, and striker bar lightly and replace the cable or install a second backup cable.

Some cables you have to pull farther than others.

Don't break the cable.

Now, if you mean the cable is not attached inside (broken), that's a lot more work.

Timebender
03-17-2013, 01:31 PM
Thanks- it looks like it's not attached to the handle, so figured I'd have to get a set of pliers in there.

I'm almost at the point of letting someone else deal with it and moving on to buying another D that's a stage II, been gone over by Danny who guarantees it's a good DD, but needs some TLC for the interior all for a reasonable price. If I get the one at work for say $8k, I could still be looking into another 10k or so plus months of work, which I'd love to do a lot of the work but have little free time, and my current DD is almost end of life at 201,000 miles - not bad for a 2000 Turbo New Beetle.

David T
03-17-2013, 04:40 PM
If the car has been sitting for 17 years it isn't worth trying to start it. You have to figure the car will need EVERYTHING. About all you can do is see if the crank will rotate, if the plastic screen in the oil fill is melted and what the motor oil looks like on the dipstick. As for not shifting, the linkage is probably all seized up from sitting. You had better buy it cheap enough because you will be essentially restoring/rebuilding every system in the car and replacing every wearable part. At least make sure the paperwork is good (a clean Title). If you spend more than $5K you are overpaying. At that price the S/S panels should be in decent shape, no broken glass and the interior not all ripped up or sunbleached. All you need is that the car can roll so it is easy to pull onto a tow truck and then park it at your house to work on it.
David Teitelbaum

Timebender
03-18-2013, 02:30 PM
That's what I figured, and I know the owner won't go below 8k - already tried with no luck. The interior actually is pretty good, as the windows are tinted really dark - only the binnacle and dash are cracked, headliner needs replacing, everything else looks pretty good though the seats could stand to be recovered someday as the leather is hard-ish.
The SS panels need to be replaced on the rear driver's side (1/2 inch hole drilled with an alarm switch), and driver's front due to a nice sized dent. The hood has some surface rust in spots from sitting outside over the past 12 years.


Moving on - sad too. Hate to see owners of any classic be stubborn enough that they'd rather see the car rot away then let someone take a whack at bringing it back to life.

Nicholas R
03-18-2013, 03:55 PM
That's what I figured, and I know the owner won't go below 8k - already tried with no luck. The interior actually is pretty good, as the windows are tinted really dark - only the binnacle and dash are cracked, headliner needs replacing, everything else looks pretty good though the seats could stand to be recovered someday as the leather is hard-ish.
The SS panels need to be replaced on the rear driver's side (1/2 inch hole drilled with an alarm switch), and driver's front due to a nice sized dent. The hood has some surface rust in spots from sitting outside over the past 12 years.


Moving on - sad too. Hate to see owners of any classic be stubborn enough that they'd rather see the car rot away then let someone take a whack at bringing it back to life.

The driver side front panel is the most expensive panel on the car. I can almost guarantee you that it will be less expensive to try to fix the one on the car then replace it.

Timebender
03-18-2013, 05:40 PM
Good advice but I'm not going to worry about it. I have the chance to get a D in DD (would that be a triple D?) condition for $15k - just needs an interior refresh.
One thing in the way- final convincing to my wife. So close... sooooo clossseeeee....

Timebender
03-21-2013, 08:20 PM
So it turns out when we were trying to get the engine to crank over once, it WAS in gear..though the shop manager told me it wasn't, even though after I suspected it was. I went in it today, grabbed the stick to find it was in 2nd gear. Going to remove fuse 7 tomorrow and try to get it to turn over once more. Engine looks pretty good actually, oil is at the first tick on the stick, white mesh screen looks great, and the belts look almost new.

I'm kind of excited.