View Full Version : Suspension Rear Brake noise
axlealex
03-28-2013, 10:47 PM
I get this clattering noise coming from the rear brakes while driving. Noise goes away when I apply the brakes. So I believe its the pads slapping up on the disc when there's no pressure. Is there a spring, or retaining clip that supposed to be on the caliper?
DeLorean03
03-29-2013, 05:14 AM
There are cotter (sp?) pins on the two bolts that hold the brake pads in the brake calipers.
Other than that, no springs or clips that I am aware of right off the bat. Some DiscQuiet on the back and sides of the pads might help stop them from being so noisy.
jmettee
03-29-2013, 07:20 AM
My right rear has ALWAYS squeaked at any speed. It goes away when I hit the brakes & is only really annoying when driving with the windows down & next to a guard rail or jersey wall. The rotor is pretty close to flat, but must have a very slight warp to make it hit the pads every rotation to make the noise. I have NOT yet tried the brake quiet gel but will probably get one of those "ketchup packets" of it next time I'm at the auto store.
I tried small springs to tension the pads away from the disc before & they worked...BUT the first press of the pedal was not secure as the pads were away from the disc - the pedal had excess travel & a second pedal pump regained that secure feeling. It was a light spring, but apparently enough to force slightly push the pistons in from vibration while driving. I would recommend NOT trying springs. Try the brake stop or get your rotors turned if you suspect they are warped & causing the chatter when the disc knocks the pads around.
axlealex
05-21-2013, 01:22 PM
So its been awhile since I posted this. Tried to just deal with the noise, but it drove me nuts. I ended up putting springs over the pads retaining pins, it seemed to do the trick. 19177
David T
05-21-2013, 10:04 PM
One cause of this is if the rotors are not cut correctly the pads ride the rotors like a needle on a record going up and then falling back down. The springs can help but the fix is to recut the rotor correctly.
David Teitelbaum
Powered by vBulletin® Version 4.2.5 Copyright © 2026 vBulletin Solutions Inc. All rights reserved.