Fuel mixture removal question

[DMC81]

I am going to remove my fuel mixture unit to replace the cap & rotor and the impulse coil, I was wanting to know two things. First....Other than the sealing copper washers Part #:102344 is that all I "have" to replace while I have it off? Second.... Can I buy these at a local parts store and if so what is the part #?

[Delorean Industries]

I am going to remove my fuel mixture unit to replace the cap & rotor and the impulse coil, I was wanting to know two things. First....Other than the sealing copper washers Part #:102344 is that all I "have" to replace while I have it off? Second.... Can I buy these at a local parts store and if so what is the part #?

I usually replace the idle tube o ring along with the copper washers. There is also an o ring under the mixture unit that once removed shouldn't be reused. It is also a good idea if you are removing the manifold completely to replace your four m7 retaining bolts at this time with a dab of corrosion protection on the threads.

[DMC81]

I usually replace the idle tube o ring along with the copper washers. There is also an o ring under the mixture unit that once removed shouldn't be reused. It is also a good idea if you are removing the manifold completely to replace your four m7 retaining bolts at this time with a dab of corrosion protection on the threads.

What is the O-ring part#, I must be looking to hard for it.

[Delorean Industries]

What is the O-ring part#, I must be looking to hard for it.

should be 102293

[DMC81]

should be 102293


Thanks Josh, I appreciate it.

[Delorean Industries]

Thanks Josh, I appreciate it.

The o ring diameter on this is actually very crucial. I was helping an owner in Florida who used a generic o ring kit from harbor freight. If the o ring is just a little too loose installation of the brass bypass tube will pull the oring into the air metering housing. It will look like it is installed but you will have a leak still. If you are going to find a replacement locally keep this in mind.