Padding on Radio/Switch Mount Plate

[kobachi]

I'm replacing the stock radio switch mount plate with one of DMCH's single-DIN plates. However, the stock plate has both a rubbery pad on the underside of the top (I believe this is part 108529, please correct me if I'm worng), and a yellow foam pad around the outside of the top. What kind of pad would be suitable to replace this yellow foam? Or is it not considered necessary?

[sdg3205]

Gently peel it off the old bracket and glue it onto the new one. Free.

[kobachi]

Gently peel it off the old bracket and glue it onto the new one. Free.

That was my first instinct, but it's adhered on there really, really well. I don't think I can remove it without tearing it. Same goes for the pad underneath.

[sdg3205]

Do you have a heat gun? A little heat and a steady hand should do the trick.