View Full Version : Frame & Body Upper Radiator Struts
Regulus
05-08-2013, 10:34 PM
Hello All,
Quick question; does anyone have experience installing/working with the upper radiator supports/struts? I've been driving around these part four years without them (!). no harm (yet), but I have them in my possession and would like to install them. Does any one know the best way to go about this? I can't find the obvious connection points on the rad itself or the frame.
Thanks,
DMCMW Dave
05-09-2013, 01:38 AM
Hello All,
Quick question; does anyone have experience installing/working with the upper radiator supports/struts? I've been driving around these part four years without them (!). no harm (yet), but I have them in my possession and would like to install them. Does any one know the best way to go about this? I can't find the obvious connection points on the rad itself or the frame.
Thanks,
They connect to the frame where you probably have a couple of bunches of ground wires. They should be on the same bolt as the wires. They connect to the radiator in holes that also hold the shroud to the radiator. You probably have a couple of small screws there that will be hard to remove as you'll be trying to keep them from turning "blind".
Mark D
05-09-2013, 11:11 AM
I just installed a new radiator a few weeks ago and have a couple pics that might be helpful.
In this one you can see how the brackets mount to the top of the radiator through the shroud
http://dmctalk.org/attachment.php?attachmentid=18980&d=1368106611
Here you can kind of see where the lower part of the brackets mount... When reinstalling the ground wires that share the lower mounting bolts check and see that you've got a good connection that is free of rust. I used some copper anti-sieze grease on the lower bolts to help keep everything corrosion free.
http://dmctalk.org/attachment.php?attachmentid=18981&d=1368108167
David T
05-09-2013, 10:55 PM
You really should have those brackets to hold the radiator from shaking. My guess is someone took the radiator out and had such a hard time with them (those little screws probably rusted and broke) so they just left them off. If you can't find a set you can always make them up out of some steel strips.
David Teitelbaum
Powered by vBulletin® Version 4.2.5 Copyright © 2026 vBulletin Solutions Inc. All rights reserved.