View Full Version : Frame & Body Bolts in footwell
I was wondering what these circled bolts are for. I discovered my passenger footwell was soaked today; I think the water came in around the boltholes and ran backwards along the floor, soaking into the foam as it went.
This was the only place I saw a damp spot!
Anyone have a pic of what's on the outer side of the bolts? Just out of curiosity.
Not sure if it was from washing the car yesterday or a couple of really heavy rain showers at a car show this afternoon...
http://i.imgur.com/iPfDLEr.jpg
David T
05-13-2013, 01:51 PM
It is unlikely the water is coming in from there. More likely is the heater box condensate drain. Try a garden hose and see where the water is getting in. Pull the fan motor and see if the box is full of water.
David Teitelbaum
DMCflux
05-13-2013, 02:59 PM
In your evap/heater box there is a drain. It comes out of a hose in the right fenderwell next to the accumulator. If it is clogged any water that comes in the vent by the windscreen will overflow the box and end up in the footwell. This is also true for the condensation that results when running your a/c.
Thanks guys, will try the hose... does anyone have photos of the general area? It's something I've never been anywhere near before, so I'd like to see what I'm looking for.
Dangermouse
05-13-2013, 04:53 PM
It's under the windscreen grille on the passenger side, under the wipers. If you spray water in that area you may find it entering in the pass side footwell for the above noted reasons.
Leaves and twigs and crud make it through that grill and plug up the drain underneath.
It's under the windscreen grille on the passenger side, under the wipers. If you spray water in that area you may find it entering in the pass side footwell for the above noted reasons.
Leaves and twigs and crud make it through that grill and plug up the drain underneath.
Ahhh yes... I think I dug stuff out of that ages ago when I had that grille removed for painting. I think I saw someone put a mesh over it, that would be a good idea.
Anyway... I found the leak! It was in fact those bolt holes.
I uncomfortably positioned myself upside down with my head under the dash while my brother ran the hose. I had him aim at the drain, but didn't see any water at all. It was bone dry. There seems to be a little rubber sleeve coming out from the heater box and going down through the fibreglass.
Next he pointed at where the wing meets the top left corner of the hood, and sure enough, seconds later a stream comes through the boltholes. It started to pool on the little ledge in the photo. Time to get the silicone sealer out!!
I think it might have leaked when I was washing the car the day before yesterday.
Thanks for all the pointers guys... some stuff to watch for in future!
http://i.imgur.com/WT04Ef4.jpg
http://i.imgur.com/k3mmjPg.jpg
http://i.imgur.com/uODpxBP.jpg
outatym2001
05-14-2013, 05:33 AM
Please see my two pictures in post number 4.
DeLorean water leaks
http://dmctalk.org/showthread.php?1394-DeLorean-water-leaks
The two bolts hold the Striker Mounting Bracket Front LH and RH.
See Frame Body page 8/4/1 in the Parts Manual and item number 49.
As David T describes there are multiple ways for water to enter the passenger compartment. Have someone spray water on the DeLorean while you are inside it with the doors shut of course. And with a flash light (torch) look for the source of the water leaks.
Yes, I know I’m posting this after the source of the leak was found.
Please see my two pictures in post number 4.
DeLorean water leaks
http://dmctalk.org/showthread.php?1394-DeLorean-water-leaks
The two bolts hold the Striker Mounting Bracket Front LH and RH.
See Frame Body page 8/4/1 in the Parts Manual and item number 49.
As David T describes there are multiple ways for water to enter the passenger compartment. Have someone spray water on the DeLorean while you are inside it with the doors shut of course. And with a flash light (torch) look for the source of the water leaks.
Yes, I know I’m posting this after the source of the leak was found.
Thanks Mark, from reading up some more, these cars have more holes than a Swiss cheese, hah.
Those bolts will be getting well plastered with sealant this evening... then the fun begins of drying out the carpet :-/
David T
05-14-2013, 09:27 PM
It is rather unusual for that to leak. Probably because someone in the past took it apart and did not seal it properly when they put it back together. You should get the service bulletin about water intrusion and just do it all. It is one of the longest service bulletins issued. You are correct, there are a LOT of places for water to get in!!!!!! After you dry it all out well make sure you kill any mold that may be there or you will eventually get odors.
David Teitelbaum
Powered by vBulletin® Version 4.2.5 Copyright © 2026 vBulletin Solutions Inc. All rights reserved.