Log in

View Full Version : Electrical Unknown Disconnected wiring in Engine Bay



jwrayth
05-24-2013, 01:16 PM
I've recently been looking at fixing the after-market cruise control on 4494, and whilst investigating the wiring in the engine bay I found two disconnected wiring plugs at the rear of the compartment. The first picture is a wider shot so you can see where the wiring goes, and the second is closer and highlights the exact connections I'm concerned about.

One has orange and pink connectors is in okay condition (circled in pink, second pic), the other is brown and black and the end has been melted since it appears to have been rubbing against the lower portions of the engine (circled in red, second pic).

I've taken a look on the colour wiring schematic, but I'm still not 100% on whether it is normal for me to be running like this. The former I think is for the engine diagnostic plug? But the latter I'm completely lost with. I've taped it up for now and used a cable tie to stop it from further rubbing against the engine, but I'd like to know what its intended use is/was!

Thanks in advance for any input :)

1922719228

Josh
05-24-2013, 01:48 PM
The orange and purple are connected to a pigtail leading to a diag plug behind cylinder 4. This is not a concern to have unplugged.

Jonathan
05-24-2013, 01:51 PM
If I'm not mistaken, those two ends you show there would plug into each other. The one with the good connector still on it is coming from the car side, and the one you've taped off would be a short length coming from the underside of the diagnostic plug itself. I believe they put a connector in the middle to make it serviceable without trying to terminate the leads coming from the engine directly to the pins on the underside of the diagnostic plug. Long story short, no harm in running this way as these are used for, as you guessed it, diagnostics.

EDIT: lol, what Josh said :)

Josh
05-24-2013, 01:59 PM
Thanks for expanding in it Jon! Both mine are melted as well

Ron
05-24-2013, 03:16 PM
Use the Orange wire to set your CO/Dwell.

Ryan King
05-24-2013, 03:50 PM
We get this question asked a few times a year. :hysterical:

jwrayth
05-24-2013, 05:54 PM
Thanks for the answer! I appreciate people taking the time to help, especially when it's something that apparently gets asked more than once! I'll be sure to help some future newbie in return!