Log in

View Full Version : Heat & A/C AC Help



Silverbullet
05-30-2013, 03:38 AM
Ok, this is what I found out today... The AC works good for about 15 minutes of driving... then it starts not being cold. So when I got home I left it running and looked at the compressor, and the clutch was not engaged. I got my volt meter, and was able to check the voltage with it still connected to the clutch, and I had 11.5 volts, and the clutch was still not engaged. I smacked the front of the clutch, and it engaged, and the AC went back to cold... I connected a gauge to the low side, and I had about 34 PSI when running... So how do I fix it? Is it a bad clutch? Is there an adjustment?

Craig

dmc6960
05-30-2013, 09:41 AM
So how do I fix it? Is it a bad clutch? Is there an adjustment?

Start by cleaning every electrical connection in the entire AC circuit. The compressor clutch is powered directly from the mode switch, through both pressure switches, then back to the compressor, with a few connections in between. I had issues like this a few years ago. I believe it eventually was a failing clutch solenoid, as I eventually needed to temporarily hot-wire it directly from the jump start post with an extra relay. After replacing the compressor with a new unit it never happened again.

I *think* there are some adjustments you can do to adjust the gap between the clutch and the pulley, but that would be for if its slipping while engaged. If yours simply wasn't engaging (due to low voltage) then you need to fix the power issues if you can.

Ron
05-30-2013, 12:13 PM
+1

See Sanden SD AC Compressor Service Manual (http://dmctalk.org/showthread.php?353-Sanden-SD-AC-Compressor-Service-Manual) in the Resource Section.
Section 10.4, Clutch Inspection, will give you Amp Draw and Air Gap (see 14.6 to adjust).

David T
05-30-2013, 02:38 PM
I had this on one car. The gap was too big. The clutch would engage but once it let go it would not reengage again. You must take the clutch apart and remove shims till you get the gap right.
David Teitelbaum

Silverbullet
05-31-2013, 03:00 AM
OK, I measured the gap, it says it should be .016-.031 and mine was .052.... So it is too big...

So can I remove some shims by just getting the 3 pin tool, removing the nut, dust plate and clutch, with it on the car?

Craig

Ron
05-31-2013, 03:36 AM
Basically, but it all depends on whether it has a keyed/spline shaft/shims before or after the key etc. It all in section 14.1 a&b.

You'll probably need a pulley puller similar to the illistration...most important thing is to have patience and not bend anything.