PDA

View Full Version : Electrical two green wires under the dashboard, driver's side - what is this?



Farrar
07-06-2013, 01:14 AM
While wiring in my cruise control to the brake pedal, I found this connector right in the same area. It has two green wires connecting to it, and it runs directly up into a harness which disappears under the dash. I haven't found it on any schematics. Can someone help me identify it, please?

20373

20372

Thanks!

DMCMW Dave
07-06-2013, 01:25 AM
While wiring in my cruise control to the brake pedal, I found this connector right in the same area. It has two green wires connecting to it, and it runs directly up into a harness which disappears under the dash. I haven't found it on any schematics. Can someone help me identify it, please?

20373

20372

Thanks!

The brake light switch wiring was changed in production from a scheme where the brake lights only worked with the ignition on to a scheme where they work any time. This is leftover from whichever one you don't have.

Nicholas R
07-06-2013, 06:36 AM
Funny, mine have always worked only with the ignition on. I must have the wrong plug connected. Never gave it a second thought.

Farrar
07-06-2013, 11:20 AM
The brake light switch wiring was changed in production from a scheme where the brake lights only worked with the ignition on to a scheme where they work any time. This is leftover from whichever one you don't have.

Fascinating! Thanks, Dave!

DeLorean03
07-06-2013, 12:05 PM
Funny, mine have always worked only with the ignition on. I must have the wrong plug connected. Never gave it a second thought.



Same here, Nick =/

DMC5180
07-06-2013, 06:41 PM
That Green Wire is LIVE all the time.

The scenario Dave describes seems Opposite to what I have too. Key ON brake lights. If the factory intended change to the Always live brake lights, why would they not have connected the GREEN wire and removed the GREEN/purple wire.

Seems more like they Started with LIVE brake lights and Changed too Key ON brake lights and never removed the green lead from Harness Drawing.

Or, they started with KEY ON Brake lights, decided make them LIVE brake lights, added the extra green wire to the harness drawing and forgot to remove the GREEN/purple lead and the workers on the line kept connecting the Green/purple wire like they always had from the beginning. "someone didn't get the memo as they say"

Bitsyncmaster
07-06-2013, 07:24 PM
Mine are the no key on needed to work. They also have a fuse in that harness for the brake circuit. So the fuse in the fuse block that says brake lights is not used.