flamingarage
09-27-2013, 09:25 AM
Hello guys,
We're having a hard time rebuilding the PRV engine for #701. Engine oil is getting into the cylinders and NOT from the valvetrain. Rings are new, liners have been honed, pistons are original and matched to the liners. We suspect that the liners have been honed too deep and this makes oil to be sucked up from below. Can you tell me what's the tolerance of the liner internal diameter?
Thanks,
Gabor
We're having a hard time rebuilding the PRV engine for #701. Engine oil is getting into the cylinders and NOT from the valvetrain. Rings are new, liners have been honed, pistons are original and matched to the liners. We suspect that the liners have been honed too deep and this makes oil to be sucked up from below. Can you tell me what's the tolerance of the liner internal diameter?
Thanks,
Gabor