PDA

View Full Version : This is why I always say the DeLorean has been the easiest car I've ever restored.



Kenny_Z
10-30-2013, 10:48 PM
I spent some time with my Mustang putting an H-pipe into the exhaust system to help the droning at highway speeds. While I was under the car the passenger floor pan looked really bad. A month ago when I started my exhaust project it looked fine but it was sagging today. I hit it with the palm of my hand hoping it was just surface rust bubbles that had formed under the undercoating. No such luck. My hand went right through it.

http://uploads.m-cgi.com/kennyz/Mustang/Projects/misc008.jpg

It looks like the previous owner missed this entire area when he did his rust proofing on the pan. I can't drive the car until I fix this. I'm just glad I saw it now before this spread into the structural part of the floor pan.

Everything on Red has been a piece of cake compared to my other project cars.

Kenny_Z
12-19-2013, 06:24 PM
I hate rust. The floors on both sides had to go.
http://uploads.m-cgi.com/kennyz/Mustang/Projects/floor09.jpg

Bet you've never had to do this with a DeLorean.
http://uploads.m-cgi.com/kennyz/Mustang/Projects/floor17.jpg

At least there's light at the end of the tunnel.
http://uploads.m-cgi.com/kennyz/Mustang/Projects/floor21.jpg

bladerunner
12-23-2013, 10:23 AM
Been there, done that :cool1:

I find floors to be one of the easier areas to weld.

ssaleen
12-23-2013, 04:48 PM
That must be a early fox? I had a 83 and a couple other 85's that didn't really have a rust in floor problem the floor just cracks and breaks on the driver's Side!! Good luck !

Jimmyvonviggle
12-23-2013, 09:57 PM
That's the good thing about mustangs, the availability of reproduction parts is incredible.

Kenny_Z
12-24-2013, 11:52 PM
And the parts are cheap. The full pans were only 50 per side. The seat pans were 60 a set. The floor pans are Chinese but the seat pans were North American. You can certainly tell the quality. I didn't feel the need to spend 120 per side on something I was going to cover with carpet. It's 19 gauge metal and the fit is close enough.

This is a 66 coupe and they were the original floors. They really didn't do too bad over the 50 years. The lack of a garage and the lousy fiberglassing job done by one of the previous owners is what really killed them.