FRAMING JOHN DELOREAN - ON VOD
www.framingjohndeloreanfilm.com
-
Older Activity
-
02-05-2025, 11:25 PM
Toby's sway bar bushing kit had slotted bushing assemblies at the body. I assume they're pretty standard sway bar body mounts? Its been so long since...
48 replies | 2001 view(s)
-
02-03-2025, 11:27 AM
It's not a problem I've had. No contact at full lock and doing parking lot figure 8s
48 replies | 2001 view(s)
-
02-02-2025, 11:21 PM
I run 16x7, 4x100, 65mm center bore, 48mm offset.
I had a 10mm spacer made to downsize 72.1 -> 65mm and center the wheel about where originals sit....
48 replies | 2001 view(s)
-
02-02-2025, 03:59 PM
I should add that with the aftermarket LCA "outriggers" you'll have less deflection.
Put some weight up front / have someone sit on the fender and...
48 replies | 2001 view(s)
-
02-02-2025, 03:50 PM
You haven't said what wheel/tire you're looking to fit.
You haven't posted alignment numbers.
How can you solve a problem that nobody seems to...
48 replies | 2001 view(s)
-
02-02-2025, 02:37 PM
Remember that when driving the wheels have friction / drag and will shift rearward. The gaps being measured here will increase under motion.
You...
48 replies | 2001 view(s)
-
02-01-2025, 07:05 PM
Point A is fixed to the frame at the ARB bushings.
UCA/LCA points B and C are free to move A LOT as they're attached by rubber bushings and ball...
48 replies | 2001 view(s)
-
02-01-2025, 02:50 PM
Lots of people are running larger overall diameter. Me too.
https://dmctalk.org/showthread.php?1035-What-wheels-rims-do-you-have
Getting rid of...
48 replies | 2001 view(s)
-
01-30-2025, 09:53 AM
For sure, if you leave chamber open it'll run bad at cold start.
Sealing it only costs a penny and some silicone.
11 replies | 846 view(s)
-
01-28-2025, 10:07 AM
Yes, this.
1 replies | 142 view(s)
-
01-27-2025, 01:38 PM
I've done this a few times and would:
-Adjust it lower spec, similar to the instructions pic
-Reassemble with the sealing cap removed from the...
11 replies | 846 view(s)
- Date of Birth
- December 8
About FABombjoy
- Location:
- Lansing, MI
- Interests:
- 80's technology, both big and small.
- Occupation:
- Computer nerd.
- Vin:
- 10270
Luke S :: 10270 :: 82 Grey 5-Speed :: Single Watercooled T3 .60/.48 :: Borla Exhaust :: MSD Ignition :: MS3X Fully SFI Odd-fire EFI :: DevilsOwn Methanol Injection
Total Posts
- Total Posts
- 1,191
- Posts Per Day
- 0.24
Visitor Messages
- Total Messages
- 1
- Most Recent Message
- 08-31-2011 05:56 PM
General Information
- Last Activity
- Today 05:11 PM
- Join Date
- 05-26-2011
- Referrals
- 0
- Home Page
- https://console5.com