Today the order from Belmetric showed up. This is every nut, bolt, and washer that goes on the outside of the transmission. Thanks 82DMC-12 -(Andy L)...
Last night I had my wife wire wheel the idle control valve so we would paint it. She did a good job but all I could think about is how much better of...
After I washed the block I took compressed air and blew the water off it. I also used the sir gun to clear the glass beads out of any tapped holes in...
I have been thinking of this a lot over the past few days so I had a good plan. I jumped right in by emptying the tubes from one kit and mixing them...
I have a guy but I would still have somehow get the studs out still. It's just not worth it. Mike at DMW is going to sell me a really nice lower case...
Scraped what I could of the timing cover gasket off then used my pneumatic tool to finish the job. Man what a pain!! This had to be one of the worst...
Yup that's the phrase I have been saying. We already have the engine down to the bare block. Gaining hp (and knowing the heads are reconditioned for...
Find latest posts