I'll be sure to impress your new neighbors with my work uniform.
Printable View
Halfway through evaporator replacement! Got the box out and disassembled. Now to sand the rusty flaps so I can get new foam to adhere before re-assembling the box with the new evaporator core, etc.
So that's whats you taking so long to get back down here. Someone is playing in the computer.
Good thing Steve posted, else this post would have been combined with my previous one regardless of timestamp.
Quick update since it's past my bedtime: We shut down a little after 9pm.
New foam from Home Depot is on the flaps -- they were rusty and had to be sanded and sprayed clean, but the foam adhered fine and I think it makes a good seal.
The sealing tape supplied with the kit from DMCMW was more than enough to do the job.
The evaporator is installed, but the heater core lines are not.
The accumulator is installed but fittings have not been 100% tightened yet.
Steve left me his vacuum pump. Later this week -- probably this weekend -- I will tighten down those fittings and vacuum out the system one evening, then leave it overnight and check the vacuum reading in the morning.
If we did the work correctly, then I should have amazing a/c when this is all done -- with the exception of the condenser, everything in the system will be less than two years old (I started buying the parts for this project about two years ago with the hoses and compressor; the most recent purchase was the evaporator kit from DMCMW).
I *do* need help adapting this early-style system to accommodate a high-pressure switch and high-pressure release valve, which were provided in the kit I received but are not shown in the workshop manual. If someone could tell me how to install it in my system, that would be most excellent.
Thanks again to Steve for all his help. I hope the ice cream made it worth the trip.
I am tired but happy -- a welcome combination of feelings. I feel like I accomplished something important today! :)