Yes, precision measurements would work. Looking for the length and diameter of the shaft that seats inside the hub nut, the with and depth of the groove for the circlip, and the diameter of the circlip itself. Thanks!
Printable View
Well as usual, now that I need it for something I can't locate it. Funny thing is I ran across it while reorganizing the garage 6 mo ago. Dang it !
Sorry about that.
Its all good.
In other news, here are some of the completed number characters...
Attachment 8927 Attachment 8930 Attachment 8926 Attachment 8929 Attachment 8928
And of course after looking at them all lined up right now, I may need to make adjustments to the middle of the 3 and 8 (slightly raise upward). We'll see though.
Hope to have the rest done by the end of this week. Then next week, drawing a whole gauge...
Decided to look in one more place on hunch and found the AD this morning. I have it with me and will get you those numbers this evening.
More Numbers...
Attachment 8943 Attachment 8944 Attachment 8942
Now the 9. Not a very important number. No possible configuration other than a BTTF 95mph unit would use one. Just in case though, I tried two things...
First, I tried just flipping the 6 so the 9 is a direct mirror of it...
Attachment 8946
Then I also tried manipulating the closed loop so it would vertically be the "smaller" loop since it is the TOP loop on the 6 and 8 which is smaller than the bottom...
Attachment 8945
At first, the mirror 9 didn't look right, so I created the modified one. But now comparing the two with the other numbers, the mirror one is probably the better one. Thoughts?
All I have left now is the 4, then I can get some of the letter characters done. Here is everything so far...
Attachment 8951 Attachment 8947 Attachment 8943 Attachment 8948 Attachment 8949 Attachment 8944 Attachment 8942 Attachment 8950 Attachment 8946 Attachment 8945
Jim, check your PM's and E-mail
I like the mirrored one best as well.
I may have messed the post referencing this, but what are the numbers for and why do they need to be remade/customized?
If these are vector images I could help you make whatever you need.
All you really need to read is the first post of the thread. In short though, I'm building an electronically controlled and backlit instrument cluster. New decals need to be printed for the gauges, and there is no perfect match for the typeface used. Therefore, I'm recreating all of them by hand using high resolution scans and measurements. They are vector drawings, as will be the final layout before its handed off to the specialized printers.
Thanks for the offer to help, but I'm almost done. :rock_on: