1 Attachment(s)
I give you... A Speedometer.
Attachment 9486
First render of a speedometer. Few nuances still remaining...
Most of the angles between ticks on the stock speedo are about 16º. However there are a few that are 15º and 14º. This variability will be too difficult to manage with my basic software for the needle. Therefore I have decided to make them all 16º. This results in the 5mph tick being a little too close to the trip rest opening. Unfortunately that opening is a fixed location, as the new shaft will need to be in the exact same spot to clear the cluster lens.
The stock speedo is biased about 2º counter clockwise. I have recreated that here, but I may keep it strait on the final product. This will allow for better 5mph placement and better overall aesthetics.
As is obiously noticeable, the km/h ticks are not here yet, perhaps tomorrow. I still need to draw a lowercase k, m, and h. With time running out I may omit that on the initial prototype prints.
The prototype I hope to bring to DCS will be an 85mph speedometer. But the final product will still be available as 140mph or all metric (240kph).
I will soon also be placing an order for a temp sender and oil pressure sender so I can use them as a measurement base without sacrificing my own car. I will be back to PIC programming soon now.
1 Attachment(s)
Generic Fuel Level Sender
Got the Saab fuel level sender today. This unit will fit inside the stock location for the OEM level sender. It reads in reverse of the OEM unit, so it is not a drop-in replacement for those without a good unit right now. I got this for two reasons, first is to have a benchtop unit for testing with the new cluster. And second is to eventually replace my original sender (still working mostly fine after 120k+ miles!). Since the new cluster will operate strictly off of logic, it is a relatively simple manner to create two programs which will operate in normal or reverse. User selectable! So the fuel gauge will work on original senders, and all DMCH reproduction senders, including the new all-in-one unit with the new fuel pump.
Attachment 9641
In addition to that, I've been reading quite a few reports lately about people having problems with their TankZilla units. It also seems that most all of the problems are with the adapter box associated with it, NOT the unit itself, which I do believe is the exact unit I just purchased. Therefore people with TankZillas will be able to bypass their adapter boxes if they wish and run their sender directly with this new cluster.