Nicely done Ryan! You have been going all out on this car since you bought it. Impressive. Most people take there time to work through these items, well done!
Printable View
Nicely done Ryan! You have been going all out on this car since you bought it. Impressive. Most people take there time to work through these items, well done!
Sweet, I hope that fix lasts!
Thanks guys. I need to balance. I think I am spending way too much time on D. :wrenchin:
Yes, I hope it lasts. I am going be very careful when I close windows.
Attachment 16177
All Spark Plugs were in the condition of #1 except #4, which was more red + white.
When I bought my D, PO told me that center vent was broken. While I was trying to fix Craig stereo, I found out that vent was actually turned inside out. Louver bar was broken but was able to fix it with fishing lines. Saved $60!!!.
And I just received this from England. I bought it through Amazon for $2.99. (Cassette was $0.01 and shipping was $2.98 ) This brings back old memories especially listening it through cassette tape deck.
http://farm9.staticflickr.com/8052/8...bfbdf09c96.jpg
I added a 3D printed logo to the steering wheel on top of the center pad leather covering. The logo was 'printed' in stainless steel. The object is 3D printed with suspended stainless steel dust particles which gives it the dimpled look. Total cost $45 including shipping. The base is 1mm thick and the letters stand 3mm at the thickest.
Attachment 16328Attachment 16329Attachment 16330
Finally finished my front end/suspension restoration!! What a difference before and after...
Replaced rear brake pads.
Drained and cleaned out fuel tank - pita. :angry:
installed DMC fuel pump combo unit. Looks nice and works well. However, I just cannot close the cover. New pump is too big. :banghead:
Rewired Craig radio harness and added aux mode. All 4 speakers are working. Hmmmm. Something didn't go right. Now cassette and radio don't work. :bash:
When I installed my combo unit I had the same issue with the cover not closing..start with the bottom screws and work your way out and up. I couldn't get the top screws in but the cover was secure enough and after driving for a few weeks the cover settled down and the top screws dropped right in! Hope that helpsQuote:
Originally Posted by Racerx
Thanks. I also screwed in bottom three. I'll wait a few weeks and see.