FYI, I’ve only installed pins on Fuel, Oil and Temp gauges. The rest do not need it.
Sent from my iPhone using Tapatalk
Printable View
https://lh3.googleusercontent.com/hM...bEE5ntcZI=w200
Through the testing (as per the video I've just uploaded via the thumbnail above) I was able to confirm the issue wasn't the wiring or sender....
I hope this helps anyone else in the same scenario!
Just adding another instance of a needle pointing dead south (6:00) and a few light raps on the binnacle got it moving again.
I know this thread is old but I have been asked by a few people if I could direct them to the photos of the needles I did for my gauges. I couldn't find what happened to the photos in my original post, so here are some new ones. Judging by the flat side of the pin, it looks like I cut down a small cotter pin for this. Sorry the one image is rotated, I'm not sure how to fix that.
Attachment 72258
Attachment 72259