Bill is so hardcore martyr you can never be on his side. Even he is not on his side, that is how hardcore Bill is! :eek7:
Do you typically leave the cover off over the pump like the photo a few pages back? What keeps water from collecting on top of the pump? Does this contribute to the short life you are seeing?
Attachment 3655 Attachment 3654
I'm not the one complaining about Airtex pumps. My first one did just fine until it sucked up a piece of Hervey epoxy (can't blame Airtex for that). My second pump did indeed suffer bearing failure. Based on subsequent headwind experiences (DeLoreans do catch headwind), I'm beginning to think my third one was replaced on a whim.
Bill Robertson
#5939
I've been trying for a while to get a boot cover without the nubs on the hose entry points cut off so I can keep one covered vs. having an open one where the return hose would go.
For that matter, I'd love an un-cut boot itself too...
Water from below isn't an issue. There is only slightly more than 1/4" clearance between the pump boot and the closing plate. Perhaps a drop or two might get thrown up and manage to be deflected in, but that's it.
That screen keeps my windshield plenum drain from filling the boot up. In a stroke of genius, Lotus put the plenum drain directly above the fuel pump -- gotta love British engineering.
Stock boot covers are a PITA to install, and they shrink, get hard, and split with age. You will bankrupt yourself and drive yourself crazy trying to keep a cover over the pump.
I can pop my pump in and out in seconds. I did just that at Virginia Beach to show someone my tuna can baffle. A screen is so much faster and easier -- and it works just as well.
Speaking of which, a Virginia Beach area owner is running a similar screen, with similar good results.
A New York area owner is too.
When taking your measurements, note that I cut my rubber too short and had to extend it about 1" with Gorilla tape -- the screen does not drop straight down but angles rearward slightly to clear the boot.
Bill Robertson
#5939
Bills distaste for DMCTalk moderation discussion can be continued here.
Everybody bitching and complaining about fuel pumps conveniently forgets that you can run a Bosch unit if you want -- you just need to knock the pressure down before feeding it to the carb.
That is exactly how one of my school buses is set up:
Attachment 3656
Bill Robertson
#5939
My vinyl skirt is too long or something; it doesn't quite fit right down in the gap like I thought it would.
But that's secondary to the fact that the new fuel pump as installed is too tall. I will have to figure out another solution. In case other carb users are curious about this particular fuel pump and how I manage it, I will let you know what I cobble together -- er I mean how I solve the problem. :)
Farrar
Take out these two components:
Attachment 4001
Their only purpose is to position the pickup screen lower in the tank.
Bill Robertson
#5939