What have you done to your DeLorean today?

Quote:

---

Originally Posted by Trstno1

Are you going to sell your old exhuast?

---

I wasn't planning on it, but people seem interested. If I decide to do so, I will start a thread and/or an eBay auction.

Quote:

---

Originally Posted by Farrar

Got these for re-installing the exhaust manifolds. Highly recommended.
http://dmctalk.org/attachment.php?at...id=33211&stc=1

---

where did you get these?

Quote:

---

Originally Posted by BABIS

where did you get these?

---

From Bel-Metric.com.

swapped the spark plug cables (ht leads) which ones that better seal off the spark plugs from the weather.

Quote:

---

Originally Posted by BABIS

where did you get these?

---

Hey those are the ones I'm using you copycat!!! ;). I'll have to check their pricing to see if it's better than my source.

Quote:

---

Originally Posted by PJ Grady Inc.

Hey those are the ones I'm using you copycat!!! ;). I'll have to check their pricing to see if it's better than my source.

---

Do you also use these studs for the exhaust manifolds/headers? :)
http://dmctalk.org/attachment.php?at...id=33221&stc=1

I got them from the same source -- they are shorter than stock:
http://dmctalk.org/attachment.php?at...id=33222&stc=1

...but I am hoping they will work anyway. [insert "crossed fingers" emoticon here]

Hi Farrar,
Those look a little sketchy as to the installed lenght and no we don't use them. As I've already posted I've had hardened stainless studs custom made for this appliction and you won't find them anywhere else unless DPI orders more from us. I've done a lot of exhaust system work over the years and have three kits available.

One is for the cost or "must be stock" conscious and the other two are for those who don't want to do this job again for an extended period of time compared to the stock offerings. We only use the improved kits in the shop.

I need to get so many of our new parts on our website when time permits so for now if you need things like this it is neccessary to pick up the phone and call us at (800)350-7429. Sorry for any inconvienance this may represent but were SLOWLY working to add to our new website.
Rob

Quote:

---

Originally Posted by Farrar

Do you also use these studs for the exhaust manifolds/headers? :)
http://dmctalk.org/attachment.php?at...id=33221&stc=1

I got them from the same source -- they are shorter than stock:
http://dmctalk.org/attachment.php?at...id=33222&stc=1

...but I am hoping they will work anyway. [insert "crossed fingers" emoticon here]

---

Finally got the front and rear suspension pulled to start my rebuild.

http://i.imgur.com/UBUR0tf.jpg
http://i.imgur.com/SbZGEfP.jpg

http://i.imgur.com/3FClnXQ.jpg

New bushing time I think? :D

Quote:

---

Originally Posted by Trstno1

.....Today I replaced my rusty fuel filler neck with a re-furbished one from DMC. :smile: Next up......fuel tank cleaning...

---

I just picked up mine replated ;)

Attachment 33246

Quote:

---

Originally Posted by BABIS

I just picked up mine replated ;)

Attachment 33246

---

Very Nice! What are you going to do about the rubber seal that insulates the filler neck from the body? I havent been able to find a replacement via DMCH.