What have you done to your DeLorean today?

Because I had one quarter panel off, today I took the other one off and decided to paint the pontoons. Also, I had to remove/replace the rusty captive spire nuts on the bottom of the panel.

General cleaning of 34 years of Georgia mud and some pine needles. I also wet sanded the black area with 1000 grit sandpaper...

Attachment 37978

Masked the area, and covered the rest of the car with plastic...

Attachment 37979

Pontoons painted with 3 coats of SEM trim Black....

Attachment 37980

All finished and masking removed...

Attachment 37981

Tomorrow I'll paint the engine cover.

Did you find any interesting Cave Paintings?

With help, I changed out my rear calipers and brake pads. First time I did brakes on a car. I also managed to break the nut loose for the angle drive and noticed that I didn't even have my new one with me.

Quote:

---

Originally Posted by DMCVegas

Did you find any interesting Cave Paintings?

---

Hi Robert,

Well, there was some markings in black marker on the inside of the quarter panels, and a code scratched into the lower pontoon. I'll take a picture of them before I put the panels on permanently.

Quote:

---

Originally Posted by mr_maxime

With help, I changed out my rear calipers and brake pads. First time I did brakes on a car. I also managed to break the nut loose for the angle drive and noticed that I didn't even have my new one with me.

---

Good job! I found that the rear calipers were a little bit challenging due to the parking brake.

Today, I painted the engine cover. The cleaning and masking took most of the time.

I masked the underside to protect my new labels from overspray...
Attachment 38012

General cleaning. The grates were dirty but the black oxide finish was in great shape. Because the top side of the cover was textured, I didn't sand it. However, you can see the fading of the paint in horizontal lines matching the louvers above it.
Attachment 38013

Top masked...
Attachment 38014

Painted with 3 coats of SEM Trim Black paint....
Attachment 38015

After using this paint twice, I like how it flashes and dries evenly, and the nozzle on the can is great. Well worth the few extra bucks per rattle can.

Very good job :thumbup:

Put some fresh gas in the tank to mix with the old gas. There is a ring of varnish about an inch from the bottom of the tank because I drained the tank incorrectly. Now I am trying to dissolve the varnish "the easy way."

Today was a long day of installing my front end.

Started with all the parts...
Attachment 38188

The fascias, louver, and front spoiler were professionally painted with the correct early VIN dark gray, in oil based paint, and SEM Trim Black. I also repainted my rock screen with satin black. I selected all stainless steel fasteners on the fascias, spoiler, and rock screen as they bear the brunt of the rain etc.

New grille retainers fastened with all aluminum 1/8" rivets...

Attachment 38189

After install...

Attachment 38190

Attachment 38191

Attachment 38192

Attachment 38193

Attachment 38194

I'll install the grille tomorrow....

Very good job :aniclap: