I did that too! What a job, but what a difference! Really worthy.Quote:
Originally Posted by iflights
Mine was from DPI, perfect fit and comes with instructions.
Fernando Silotto. Sao Paulo - Brazil
Delorean Vin 3772
Printable View
I did that too! What a job, but what a difference! Really worthy.Quote:
Originally Posted by iflights
Mine was from DPI, perfect fit and comes with instructions.
Fernando Silotto. Sao Paulo - Brazil
Delorean Vin 3772
Tearing the car down for all new brakes, susupension, fascia painting, rims, tires and other custom stuff!https://uploads.tapatalk-cdn.com/201...384f25c23c.jpg
Sent from my SM-N920P using Tapatalk
Attachment 51715Attachment 51716Attachment 51717
I think the windshield was replaced at some point and the trim was poorly/sloppily attached back and was separated when I got the car. Finally got around to squirting some silicone adhesive behind it and clamped it back up. Ended up using a simple flexible drinking straw which was able to get in between the glass and trim to apply the silicone.
got bored during lunch, so i started painting some of the less "aesthetically pleasing" bolt heads (especially the fuel banjo bolts) with a silver sharpie.
Attachment 51766
Sure it's not a permanent fix, but it cleaned up the little details of the engine bay nicely for now.
Looks good to me! Damn clean!Quote:
Originally Posted by novadmc
Sent from my SM-N920P using Tapatalk
Drive Stainless rear coilovers, cooling system flush, lock & latch adjustment on the passenger side (my daughters can open the door now,) and got my first state inspection.
NYS now requires a [somewhat] current safety inspection for registration renewal, so I had to go legit to keep my '80S METL' plate.
Check it out, DeLorean Grey....it matches the car:
Attachment 51791
Figured out that even though the glove compartment looked closed, it was not latched and the light was on (partially obstructed by the dash mat). IIRC, that incandescent light pulls about .2 amps ...which may explain why the battery was occasionally dead. Now the total drain when the car is off is .01 amps. I suppose I should chase down an LED alternative just in case.
I ordered several bulbs for the glove box door light because they were from China. Funny, its the only bulb in the whole car that screws in and is the most difficult to find a LED replacement. Im sure you know all that though. The LED replacement lights up the glove box nicely. Glad to hear you got it fixedQuote:
Originally Posted by nkemp
Sent from my SM-N920P using Tapatalk
Ripped out all the right rear suspension and brakes today to be replaced with all new Replacements and QA1 adjustable coilovers all the way around. Nice trailing arm bolt if I may add. Also my son was helping out polishing the exhaust system!https://uploads.tapatalk-cdn.com/201...f721b212a4.jpghttps://uploads.tapatalk-cdn.com/201...9c549db051.jpghttps://uploads.tapatalk-cdn.com/201...0b163c25f4.jpg
Sent from my SM-N920P using Tapatalk
Do you know what the correct bulb type/number is for the LED replacement? ThanksQuote:
Originally Posted by Christian Dietrich