What have you done to your DeLorean today?

Thanks everyone, it is so nice not to have that bend looking at me each time I see the car. I got my new coolant bottle mostly in, still waiting on the brackets to dry.

http://uploads.m-cgi.com/kennyz/Delo...s/bottle03.jpg

I cleaned and painted my front calipers red. I know they are supposed to be cad plated gold but I like the red.
http://uploads.m-cgi.com/kennyz/Delo.../caliper01.jpg
http://uploads.m-cgi.com/kennyz/Delo.../caliper03.jpg

I also started fixing this...
http://uploads.m-cgi.com/kennyz/Delo...ts/cover01.jpg
http://uploads.m-cgi.com/kennyz/Delo...ts/cover06.jpg

Quote:

---

Originally Posted by opethmike

Drove mine a good 35, 40 miles today. Showed it off to some friends who hadn't yet seen it with the EFI/Spec 2.

---

HA! Me too! minus the EFI/Spec 2 part. I took mine for the first drive since finishing installing the DPI exhaust last week and showed it off to/took some friends for rides. It put such a smile on my face.

Got most of the interior out before sunset.

Attachment 8799Attachment 8800

Bought a new output flange seal.

Attachment 8802

Ordered a bunch of hardware from McMaster, including jack nuts to replace missing nuts in rear fascia.

First I will JB-Weld the seat studs back on, and then I will de-rust the metal with my Dremel's wire wheels and re-paint with black Rustoleum.

Polished some tubes

http://i31.photobucket.com/albums/c3...c/SSPX0062.jpg

When I get back from Florida on Saturday, I will be replacing my A/C evaperator and if my order arrives from Houston by then, installing a headliner set. Pretty excited about the A/C, okay I'm lying I'm not looking forward to it at all.

Quote:

---

Originally Posted by seventy4burban

When I get back from Florida on Saturday, I will be replacing my A/C evaperator and if my order arrives from Houston by then, installing a headliner set. Pretty excited about the A/C, okay I'm lying I'm not looking forward to it at all.

---

I am about to do the evaporator job as well. Prep involves removing the seat and carpet and putting a pillow down since I will be working upside down so much. :lol: Good luck! :)

Gave the underneath a good spray-off. Looks niiice. Probably will take it home from the shop tomorrow and fiddle with the non-functioning passenger door. What a PO that door is.

Finally got the trunk backer boards cut. This 1/8" hardboard is deceptively tough stuff to work with as almost every tool is way too much for it. That's my story and I'm sticking to it.

Quote:

---

Originally Posted by jawn101

Finally got the trunk backer boards cut. This 1/8" hardboard is deceptively tough stuff to work with as almost every tool is way too much for it. That's my story and I'm sticking to it.

---

I was planning on using 1/8" ABS plastic. I will let you know if it works out any better than masonite, but yours looks pretty good to me!

Quote:

---

Originally Posted by Farrar

I was planning on using 1/8" ABS plastic. I will let you know if it works out any better than masonite, but yours looks pretty good to me!

---

I'd bet money it will be more durable and less likely to warp, especially given the differences in climate between where you and I are. Plastic didn't even occur to me if I'm honest, this is just the same stuff I made my new seatbacks out of and it was handy :)