That's one of the nice things with enamel paint. No critical times to add the second coat and no prep needed between coats. Only thing I don't like is solvent will soften it.Quote:
Originally Posted by Farrar
Printable View
That's one of the nice things with enamel paint. No critical times to add the second coat and no prep needed between coats. Only thing I don't like is solvent will soften it.Quote:
Originally Posted by Farrar
With any luck, I won't have the seats sitting insolvent like they sat in water. Fingers crossed!Quote:
Originally Posted by Bitsyncmaster
Removed the rest of the engine cover vents, retaining strips, and 50 clips. Missingeons 300mm strip. Everything for sale in the next few weeks. Need to hold on to them for a little longer for measurements.
Repaired Craig Display
Attachment 9137
New Headliner installed. The folks at DMCFL did a great job!!!
Here is a pictureQuote:
Originally Posted by sadeeky
Have you had any luck finding replacement belts for the tape mechanism? My radio works great but the tape drive is shot as the belts and band have turned to mush.
Steve
Quote:
Originally Posted by Jack
Before the display broke I attempted to have the belts replaced by a local stereo place.Quote:
Originally Posted by mluder
There wasn't even enough belt left for them to figure out wow many it had or which way they run.
I've never seen a functioning tape deck in person, nor found a picture online of the belt/s orientation.
Plus according to the shop the load mechanism was shot.
The band to my knowledge has to be repaired otherwise the entire display has to be swapped from a donor radio.
The wires I ran are non flexible so I have "jammed" the display to stop people from pushing the display in.
Which by the way was how it got broke in the first place.
Got the air conditioner charged.. I have A/C now!!! Started installing new headliners. About 75% done. Just have to cut and glue the right side up and install the passenger door piece.
-- Sent from my TouchPad using Communities
Pulled my transmission off, took me a while to figure out how to remove the shifter cable. Rebuild process will begin Saturday hopefully.