Printable View
Ugh I feel this deeply. We have very hard water in my town and I washed the car one time with it. Hot vinegar will do a lot to remove the spots but may not be totally perfect. I had to take a few off with a blending pad. Since then I have installed a water softener in the house and only wash the car with a hose hooked directly to it, no more problems.Quote:
Originally Posted by Bitsyncmaster
Got my car running good (knock on wood). I think the problem was a bug in my lambda ECU software but I did other software improvements in it also.
Anyway my car has a vibration (sounds like the dash is vibrating) under heavy load (hard acceleration or going up hill). I think I will first empty my glove box and test, then I think I can use some sand bag weights to determine if and where the dash need work.
Found and fixed one of the vibrations I'm getting with hard acceleration (worst in third gear). My ECU metal plate (holds the three ECUs) was only held down by one screw. The others had to cut off a long time ago. I now have it screwed down with three screws.
But still have a vibration which sounds like behind the driver. Thinking it is my sun shield. I think I need to adjust the latch tighter so it takes a little down force to lock closed.
Today I put the carpeting into the trunk. I got them from DeLoreanGo and they didn't quite fit exactly. I had to cut them a little bit ultimately around where the door strut attaches and along one of the edges that was very off. But, I'm pretty happy with how it turned out!
Attachment 69885
Earlier in this thread I asked about why the seam between the door and the door panel looked all janky. It was not made janky at the factory. It was someone who did a poor job reassembling the door panels and all the stuff poking through was disintegrating duct tape.
That's how mine is also, I believe it's factory and just has not held up over timeQuote:
Originally Posted by paullckby
Just tried FORMULA 409 spray cleaner and it seems to remove water spots from glass and even helps lessen the spots on the SS.Quote:
Originally Posted by Bitsyncmaster
Softened water (or rain water) is a must ... in the shade. I use a squeegee to remove the water and then towel it. Something you could try on the spots is CLR given that the spots are likely Calcium. Vinegar might work as well. Good luck.Quote:
Originally Posted by Bitsyncmaster
I recently got a 3d printer and been having a blast. Made a few things:
New latch cover for the glove box since my old one kept popping off (never mind the taped up kneepad). Attachment 70000
Made a pair of A/C vent caps. Attachment 69998
Made a couple brackets for the door switches for extra strength. Attachment 70002 Attachment 70003
A blanking cap for the passenger side door. Attachment 69999
Alignment plate for the console switches so they don't bottom out and bind. Attachment 70001
Really impressive.Quote:
Originally Posted by bytes311
Really impressive. Would you be willing to share the .stl files used? If not all, please consider sharing out the one for the door switches. As you are aware, that bezel is a great solution for that area.