I was thinking about that. At least I can do that later with the hood already installed.Quote:
Originally Posted by Timeless
Printable View
I was thinking about that. At least I can do that later with the hood already installed.Quote:
Originally Posted by Timeless
It takes two packs. I put my seams near the bottom/front of the hood where I thought they were out of sight and not a place I considered to leak.Quote:
Originally Posted by 82DMC12
Yesterday I sprayed the underside of my hood with SEM Trim Black. Most of it looked great except for a couple areas that had a mottled appearance, apparently from remaining contamination despite sanding everything down and cleaning with lacquer thinner. I ended up wet sanding my new finish with 175, dry sand with 400, and this time used SEM High Build Primer (2 coats) before spraying 2 more coats of Trim Black.
Note to anyone else doing this - USE THE PRIMER!
The finish is much more uniform and appears factory-fresh.
Attachment 70401
Just after spraying two coats of High Build Primer
Attachment 70402
A few minutes after the second coat of Trim Black
Attachment 70403
Close up of the finish after drying for about an hour
If it's not too late, follow up with a coat of clear, I prefer the matt but the semi gloss looks good too.
Lovely stuff, looks really well
I was in the mood to hate myself and do some self-flagellation this weekend so rather than go the easy route with the self-adhesive gasket I spent two whole freaking days installing the DPI gasket with weatherstripping adhesive. I'll spare the gory details but I'll put them in my build thread
https://dmctalk.org/showthread.php?1...ff-restoration
Anyway, the hood turned out SPECTACULAR! Certainly a labor of love. I spent quite some time last night working on hood and hinge alignment, and then ended up removing the hood release mounting bracket so I could file the holes down about 3 mm so I could drop the hood flush to the fenders. Best fitment I've ever had!
Attachment 70407
Close up of the corner-work. It takes about two hours to turn a corner.
Attachment 70408
Finished product
Attachment 70409
Notched hood release bracket, done by hand with a file.
Painted faded quarter panel vents with Wurth satin black trim paint.
Attachment 70442Attachment 70443
My left side vent has some minor damage to it. How would you recommend fixing it? Fiberglass resin? Bondo?https://uploads.tapatalk-cdn.com/202...de676386e2.jpgQuote:
Originally Posted by Timeless
Sent from my SM-F926U1 using Tapatalk
Jb weld or some panel bond then just lightly sand it down and paint.. make sure to sand a bit first to rough it up for the stuff to stick...
Do you have a power antenna installed or was there one there? This notches on your vent fins are usually hand filed into the vent to allow the power antenna to clear past the vents. If you have a power antenna and repair those notches or replace the vent, the antenna will not be able to fully extend and could either get damaged or damage the vent.Quote:
Originally Posted by SupercoolBill