Search:

glock, did you inspect your throttle plate decel springs? There is a great thread here with a brass screw set procedure that many swear by.

More info from yesterday:
With the stock gauge reading 1/4 the fuel tank took 10.58 gallons. [DPI pump kit]

Good news it's not a more significant issue. For over 10 years I never had issues with FelPro gaskets at my shop although, they could be made with subpar quality now. (i.e. China)

If you need a laptop operator assistant I'm game :thumbup2:

What mindset does a person have to do this? Obviously they have the funds to acquire thousands of dollars worth of vehicles but why not take care of them and store them away from the elements. Kept...

Original ISM replaced with a functioning ISM (500) and the hunting has stabilized. I did a quick attempt to seal the original with 3M strip-calk and it did not help. I may do a more through repair to...

I get my D to higher speeds often (S.FL). The only reason not 90+mph is the automatic transmission. I don't like keeping the engine at ~4000+RPM for extended time periods.

I left a comment on your YT page. Excellent achievement sir! :cheers1:

If and when my D's headliners need attention - I was considering alcantara or similar material. I love the alcantara headliners in my other vehicles.

Ditto.

Defroster switch SOLD.

I may be interested if you decide to part with them.

https://dmctalk.org/showthread.php?16133-Fastening-the-hood-down/page2&highlight=HOOD+SEAL

Thanks man! I'll get some.

Has anyone used/tested the BOSCH Bosch 0 332 209 151 relay? I'm thinking of getting these to replace the non solid-state OE relays. (I have DM RPM, hot start & fan relays)

So great - so cheap.

Screws are tight but I'll loosen and see if I can manipulate/adjust the hinges. The rear screen finisher looks to be in good shape and yes - the T-panel is being pushed up when lifting the louvres.

All back together. Vacuum lines on replaced, few electrical connections cleaned at bulkhead, new plugs, DPI injector seals, ignition timing set. Smoke test revealed idle control motor is leaking - no...

Recently had my louvre start not shut correctly. It feels like there is tension when down with slight force required to latch it to engine cover. The top is contact the T panel when opening. Any...

Set of valve covers: $200.
Idle ECU: $200.
BOSCH OE ignition cap & rotor. $85
693316933269333

https://dmctalk.org/showthread.php?17938-LSEAT-Leather-seat-covers&highlight=LSEAT

Installed original Idle Air Control Valve and module. Tested power and ground to module. Used oscilloscope to verify inputs and outputs from Control Module. System uses inputs from Throttle Switch,...

FWIW my DPI setup is new - installed in August 2022. My fuel gauge reads differently vs. stock setup.

I have experienced that with low fuel in the tank. OE gauge reading close to 1/4 really equates to my car having VERY low fuel. I fill up when at ~1/4 to not risk running out of fuel. One stop...

Anyone with experience with these 2?

https://3dproducts.com/collections/paint-trim-car-products/products/3d-trim-care-protectant-restorer-plastic-trim-bumpers
...