FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com

Search:

Type: Posts; User: TheStoot

Page 1 of 4 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    83
    Views
    64,373

    [General] This is how I wired my Eagle starter up

    This is how I wired my Eagle starter up
  2. Replies
    12
    Views
    1,461

    Hey there! I'm up here in northeastern ,ma . I...

    Hey there! I'm up here in northeastern ,ma . I drive mine almost daily, not as a commuter car as I work in Boston, but as my fun car once I get home. I also attend a few car shows a week. I share em...
  3. Replies
    9,081
    Views
    2,748,889

    [General] Installed the Duralaat starter from autozone,...

    Installed the Duralaat starter from autozone, #61984. Very easy install, found the previous owner had broken 1 of the bolts off on a mounting tab and rather than replace the bolt, put a roll pin in...
  4. No offense , but it's a DELOREAN forum. Just...

    No offense , but it's a DELOREAN forum. Just cause u own one, doesn't mean anyone cares about the whole outboard motor buying gig
  5. Replies
    2
    Views
    739

    I built mine from scratch and got everything to...

    I built mine from scratch and got everything to hold together going 80mph down the highways since last year69296
  6. Thread: Idle hunt

    by TheStoot
    Replies
    101
    Views
    7,388

    [Engine] Lambda ecu

    I'd be interested in sending you my stock unit to swap out as my cars garaged for the winter currently
  7. Replies
    21
    Views
    3,967

    [For Sale] Parts

    I am looking for a parking brake bracket, the one the parking brake handle bolts into
  8. Replies
    10
    Views
    987

    [Engine] I replaced mine over the summer I believe it was...

    I replaced mine over the summer I believe it was 40mm
  9. Replies
    5
    Views
    1,687

    [For Sale] I'll give ya $600

    I'll give ya $600
  10. [For Sale] These for a stock prv? I've wanted to clean mine...

    These for a stock prv? I've wanted to clean mine up and redo the gaskets but these ones are ready to go. $200
  11. Replies
    9
    Views
    1,431

    [Frame & Body] Don't use silicone spray, won't do much for it....

    Don't use silicone spray, won't do much for it. Make sure to use silicone grease, makes a huge difference
  12. Replies
    20
    Views
    2,782

    [Fuel] Yea like Dave said 02 sensor has no effect on...

    Yea like Dave said 02 sensor has no effect on whether it buzzes or not. Leave it disconnected and u shoukd get 50% and buzzing all the time. I had the same problem and it ended up being my lambda...
  13. Replies
    0
    Views
    499

    [General] engine cover hinge

    Does anyone have a spare engine cover hinge they would want to sell? Hit me up on here or on facebook, Jason Keohane
  14. Replies
    13
    Views
    1,880

    [General] I'm with Josh on this one. I got a new slave and...

    I'm with Josh on this one. I got a new slave and master, new clutch fluid and new gear oil in the transmission and Mine is hard to shift when it gets down in the single digits +. I would say what you...
  15. Replies
    40
    Views
    6,644

    [General] In Massachusetts, the sales tax is determined by...

    In Massachusetts, the sales tax is determined by book value of the car, whether its NADA guide for older vehicles or KBB for newer. Bill of sale is not used for sales tax unless it is at a higher...
  16. [Frame & Body] I get where you're going with this one but that...

    I get where you're going with this one but that unlock switch is pretty rigid, you could do it i guess. This is probably the only way i've seen it menntioned that would have a chance at working. I'm...
  17. Replies
    21
    Views
    2,623

    [General] I replaced mine w delorean go version last...

    I replaced mine w delorean go version last October with the polyurethane one, split it and installed no problems 5000 miles later
  18. Replies
    5
    Views
    828

    [Electrical] yea same happened to me. My switch was fine but...

    yea same happened to me. My switch was fine but the wiring got melted along the exhaust crossover pipe somewhere underneath. Ran a new wire and all was happy again!
  19. Replies
    9,081
    Views
    2,748,889

    [General] After coming home from a car show I figured I'd...

    After coming home from a car show I figured I'd check under the car to see how everything was doing since I had been on a few longer trips recently. I found the passenger side steering rack boot torn...
  20. Thread: BTTF hardware

    by TheStoot
    Replies
    0
    Views
    2,033

    BTTF hardware

    Is anyone familiar with the tdc drive switch mainboard from bttfhardware.com? I recently found one and was wondering how it works and what it actually does?> I assume it links all the different props...
  21. Replies
    12
    Views
    1,486

    Poll: [General] I think that it's a combination of factors that...

    I think that it's a combination of factors that make it such a unique car. I've had so many people come u p to me and say i've never seen one in person before, yet they know exactly what the car is....
  22. Replies
    3
    Views
    3,616

    I agree. David makes incredible products for our...

    I agree. David makes incredible products for our cars that truly bring them up do date electrically and do improve upon a lot of original stuff. My car is much more reliable with dave's electronics.
  23. [General] I hear ya, kinda. I didn't buy my car to be a...

    I hear ya, kinda. I didn't buy my car to be a garage queen or keep it low miles for the next person. I bought it to drive it and be seen driving it. Mine was kept in a museum for the past 28 years....
  24. [General] If I got my car shipped it would have been along...

    If I got my car shipped it would have been along a not so main route so it was looking like 2-3k to ship from Mississippi to Massachusetts. I didn’t wanna spend the extra money to ship so I just...
  25. I went through this once. They had a pretty legit...

    I went through this once. They had a pretty legit looking website and everything. The guy even responded to emails and we talked over the phone multiple times, though his accent didn’t really match...
Results 1 to 25 of 98
Page 1 of 4 1 2 3 4