FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com

Search:

Type: Posts; User: Ron

Page 1 of 20 1 2 3 4

Search: Search took 0.20 seconds.

  1. Replies
    18
    Views
    748

    [General] Hey Andy, (I didn't reply before because you...

    Hey Andy,
    (I didn't reply before because you don't have a drawing to go with the terminal numbers you call out...)

    Yes, the black bit is the harness.
    There is no diode in the UY wire. That...
  2. Replies
    23
    Views
    19,926

    ...especially so when you use the wrong values...

    ...especially so when you use the wrong values and ground. :smile:
  3. Replies
    23
    Views
    19,926

    The only difference between using analog or...

    The only difference between using analog or digital is that it is harder to read a pulsing signal with a digital.
    Select 8 Cylinder (set it to swing/pulse across 20).

    [IIRC, you will get ~27...
  4. Replies
    20
    Views
    3,785

    LOL - Yeah, I guess the PPR wouldn't have...

    LOL - Yeah, I guess the PPR wouldn't have anything to do with since it's eliminated along with the FD.

    I think I'll ban myself from the EFI section...:bang:
  5. Replies
    20
    Views
    3,785

    (Assuming you confirmed that the ECU is getting...

    (Assuming you confirmed that the ECU is getting the signal to prime during failures...)

    I'd say that the ECU is the better bet since normal D rest pressure is less than 50psi [3.3 Bar], and, the...
  6. Replies
    39
    Views
    1,535

    [Fuel] My understanding is that it works differently...

    My understanding is that it works differently with copper -- With copper, how fast you quince it does not matter a lot.

    I know that jewelers heat and quench copper to soften it after working it....
  7. Replies
    39
    Views
    1,535

    [Fuel] The washers should be flat on both sides. When...

    The washers should be flat on both sides.
    When new, they are soft and crush to form a good seal when torqued down. Torquing them down makes them harder. You can make them soft again by annealing...
  8. Replies
    66
    Views
    22,223

    [Heat & A/C] My experience and research over the years: R134a...

    My experience and research over the years: R134a has a lighter molecular size, lower heat transfer rare, requires a larger condenser, runs at higher pressures, and results with ~5F lower output air...
  9. Replies
    66
    Views
    22,223

    [Heat & A/C] If you are going R12, use the GM. I've never used...

    If you are going R12, use the GM. I've never used a variable on a D...mixed stories, mostly not good....
  10. Replies
    66
    Views
    22,223

    [Heat & A/C] Get one of these:...

    Get one of these: https://www.centurytool.net/Gm_Ford_Screen_Extractor_p/msc91009.htm

    Or you can use a screw. Either way, make sure you run it eight down the center to avoid piercing the tube.
  11. Thread: Starter shortage?

    by Ron
    Replies
    26
    Views
    2,618

    [Engine] YW! "Remy", or Delco-Remy, has a popular D...

    YW!
    "Remy", or Delco-Remy, has a popular D replacement alternator...

    The Ultima R612473B is a very popular D replacement starter.
    Check out the pic showing an original and an Ultima with the...
  12. Thread: Starter shortage?

    by Ron
    Replies
    26
    Views
    2,618

    [Engine] I can't see the part numbers in your attachment,...

    I can't see the part numbers in your attachment, but I can see that the upper one is not correct (two vertical bolts). The lower one looks correct and should be part number R612473A.
  13. And On The Lighter Side...

    [/QUOTE]
    (See my avatar).


    Sounds like...Steve Rice?

    ================

    To all- While I don't see where anyone has really crossed "the line", it seems like a lot of toes are lining up on it....
  14. Replies
    8
    Views
    580

    YW! IIRC, the wire is copper. It appears long...

    YW!

    IIRC, the wire is copper. It appears long enough to reuse to me, so I'd avoid any resistance issue (using a guitar string).

    You will have much better luck soldering copper in any case.
  15. Replies
    8
    Views
    580

    There is nothing special about that wire. It...

    There is nothing special about that wire. It brings in 12v from the light...
    It connects to a contact that seems to missing in your vid (among other parts). Probably corroded away:


    68800
  16. Thread: Air cleaner

    by Ron
    Replies
    12
    Views
    747

    [Engine] In Resources...

    In Resources


    AC: A815c, Bosch: AF235, Champion: AF343, CrosslandL 042115, Fram: PH287A, NAPA: 6112, NOPI: AF-235, Purolator: AF14275, Volvo: 269308-3, WIX: 46112, World: W27-623
  17. Replies
    11
    Views
    1,119

    You have that backwards- The buzzer switch has...

    You have that backwards- The buzzer switch has the PW and PU wires. The switch for the left door lights are PU and B.

    Fuse 12 feeds power to one side of the door bulbs with a P wire. The other...
  18. [General] Seems like someone watched a lot of Speed Racer:...

    Seems like someone watched a lot of Speed Racer:

    68739...68742

    :p
  19. Thread: Cleaning injectors

    by Ron
    Replies
    2
    Views
    299

    [Fuel] If it ain't broke...hit them with a little oven...

    If it ain't broke...hit them with a little oven cleaner and/or sew it back up.
    (Any other cleaning should be on a machine. Give thanks! ;-)
  20. Replies
    4
    Views
    842

    :thumbup:

    :thumbup:
  21. Thread: Trunk Tool Kits.

    by Ron
    Replies
    23
    Views
    1,131

    [General] Starting Fluid for: cold starts, checking...

    Starting Fluid for: cold starts, checking air/fuel/vacuum leaks, cleaning...
    Spark plug to check ignition...
  22. Replies
    1
    Views
    518

    Hello TMB, Please note that the FAQ Section is...

    Hello TMB,
    Please note that the FAQ Section is reserved for previously answered questions.
    Your original post was moved to the How To-REQUEST LIST thread and answered HERE.
    If you need further...
  23. Replies
    23
    Views
    4,386

    Hey Rich, This thread was in the For Sale &...

    Hey Rich,
    This thread was in the For Sale & Services / Want To Buy section and moved here because that section is reserved for "DeLorean Items you own and would like to sell. DeLorean Services you...
  24. Replies
    24
    Views
    4,227

    [General] Here'...

    Here's a link to one for the 1980 Chevy Monza listed above.

    I'm thinking CW looking into the cage/wheel...Air should travel into the center and exit through the side....
  25. Replies
    10
    Views
    613

    [Electrical] There should be a brown with yellow stripe wire...

    There should be a brown with yellow stripe wire at the alternator. It comes from the battery light bulb (12v, Fuse 5). If you ground it while disconnected (Key in Run), the light should come on.
    ...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4