After proper service I have great AC cooling but have noticed that there is no cycling.
On the low side, when just starting up, the pressure is 45, which is fine. At 3000 RPM the pressure drops to 25, which for my switch is not quite low enough to turn off the compressor.
On the cycling switch on the accumulator, I noticed that it was loose so tightened it back down (may have been the source of my leak). But anyway, when I remove it and look at the inside, do I turn the little adjustment tab CW or CCW to adjust it so it will cycle the compressor off when I get to 23-25 degrees? Two rather conservative 1/16th inch turns in either direction did not seem to do anything, so rather than go too far thought I would ask.
Steve