FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com
Results 1 to 3 of 3

Thread: Cleaning injectors

  1. #1
    Senior Member
    Join Date:  Dec 2018

    Posts:    1,028

    Cleaning injectors

    I just pulled my injectors to test the spray and install new seals. I had tested each one a long time ago to see if they worked but never altogether to see if it was a balanced amount of fuel. They all seem to spray fine, balanced and shut off at once.

    My question, how to clean them? I took some scotch brite and cleaned them a bit and installed the new rubber. Is that it? How about the little holes on the side? Should I poke them out with a pic? Are they holes?

  2. #2
    Administrator Ron's Avatar
    Join Date:  Jun 2011

    Location:  North GA

    Posts:    6,001

    Club(s):   (SEDOC) (DCUK)

    If it ain't broke...hit them with a little oven cleaner and/or sew it back up.
    (Any other cleaning should be on a machine. Give thanks! ;-)

  3. #3
    Senior Member
    Join Date:  May 2011

    Location:  Northern NJ

    Posts:    8,310

    My VIN:    10757 1st place Concourse 1998

    If they are all spraying good patterns and equal amounts they do not need to be cleaned. if you still want to do something use a bottle of Techron in a full tank of fuel.
    David Teitelbaum

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •