New owner looking for help

[Lumpyd]

Ok, just got 5167 and I have a LOT of questions. I'll start with the engine bay. What is the little gold dipstick looking thing on top of the motor? And I have some disconnected wires. One I believe is for the engine bay light that will have to be replaced. But the other is a connector with a black wire and a red wire going into it. Right up by the firewall. Any ideas?

[WHO1DMC]

Ok, just got 5167 and I have a LOT of questions. I'll start with the engine bay. What is the little gold dipstick looking thing on top of the motor? And I have some disconnected wires. One I believe is for the engine bay light that will have to be replaced. But the other is a connector with a black wire and a red wire going into it. Right up by the firewall. Any ideas?

The plug is probably the unused mystery plug. The little dipstick thing is the CO adjustment screw plug. I wouldn't touch it. If it's been in there for a long time you can lose vacuum if it doesn't seat rite.




Dave B.

Sent from my SM-G991U1 using Tapatalk

[Lumpyd]

Thank you

[Timeless]

You'll find a plethora of information here and owners willing to assist. Welcome!

[Ron]

The black and red wires go to a 1uF capacitor, for radio noise suppression.

[82DMC12]

Actually that particular plug is supposed to connect to a two-pin harness behind the engine, that has a black wire and a black/blue wire. Yes, the wiring colors change at that plug! No idea why. Probably why it's not plugged in.

Here is a photo of the engine-side plug. Also a picture of the two plugs connected on the firewall. Good luck finding the other end! It must be back there.

PXL_20221018_211240273.jpg

PXL_20220122_220204142 (1).jpg

[Lumpyd]

Awesome. I'll check for it. Now, while we're back here, there is a hose attached to a plastic "T". Is that a fuel line?

Screenshot_20230317_191210_Chrome.jpg

[Rich]

Awesome. I'll check for it. Now, while we're back here, there is a hose attached to a plastic "T". Is that a fuel line?

Probably a coolant hose. No fuel line tees are back there unless it has a PO mod.
Requesting another photo.
Can you use an arrow to point to the hose and/or the tee you’re asking about?

[Lumpyd]

Check out the link in my above post. Not sure how I attached the pic in my first post.

[82DMC12]

It's hard to see but I believe it is a Tee for the brake booster?? Check out part #5 in the diagram. It goes onto a hose barb on the back of the passenger side intake manifold.

https://store.delorean.com/parts/bra...nes-hoses.html