I just wanted to check with others doing EFI if they ever had issues with EMI using the DeLorean.com silicone wire. I would like to say the quality was fine and see no issues there. I always inspect new parts as a put them on and could not help but notice what I thought was a solid copper wire folded over and crimped on the end that goes on the distributor. This would not cause to much issue for the K-jet but it will cause major issues for a uP based EFI system. I did not want to pull the new set of wires apart to get a better look but wanted to ask if anyone else noticed that. I plan to confirm this week but wanted to share with everyone that you can not run solid core plug wires with EFI or you will have major issues with noise and the ECU cutting out oe loosing sync.