FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com
Page 2 of 2 FirstFirst 1 2
Results 11 to 14 of 14

Thread: Hardware & Integration

  1. #11
    "Former Delorean owning Guru" Spittybug's Avatar
    Join Date:  Jun 2011

    Location:  Hill Country, TX

    Posts:    1,578

    My VIN:    Formerly 2329

    Replacement Rear Harness (when you don't have K-Jet junk)

    Polyester looming. Female bullet connectors crimped down a bit. Labeled on bullet end. Shrink tubing at intersections. Electrical tape under shrink tubing to get good bond. All connectors soldered, no crimps.
    • A/C pigtail
    • Oil light
    • Otterstat
    • Reverse switch
    • H2O temp
    • Auto transmission knockdown switch

    • Starter wires
    • Alternator wire
    • Oil pressure sender


    Add in a 12V+ bus bar and new red cables to alternator, battery, starter and bulkhead connector and you have a nice clean engine bay. Of course a new modern coil will let you remove the ballast resistors, putting a toggle switch on the engine bay light eliminates the one on the firewall and the whole start relay thingy can go too with new red wires just described..... clean.
    Attached Images
    Owen
    I.Brew.Beer.

  2. #12
    Senior Member Bitsyncmaster's Avatar
    Join Date:  May 2011

    Location:  Leonardtown, MD

    Posts:    8,679

    My VIN:    03572

    Mercury switch the engine bay light.
    Dave M vin 03572
    http://dm-eng.weebly.com/

  3. #13
    "Former Delorean owning Guru" Spittybug's Avatar
    Join Date:  Jun 2011

    Location:  Hill Country, TX

    Posts:    1,578

    My VIN:    Formerly 2329

    Distributor Readiness for EFI (or to change your impulse coil)

    I just did this job for another guy that is going EFI, so I thought I would document it. Sean, do you want to put this in the resource or how-to section as well?

    PDF file contains step by step procedure with pictures. Enjoy.
    Owen
    I.Brew.Beer.

  4. #14
    "Former Delorean owning Guru" Spittybug's Avatar
    Join Date:  Jun 2011

    Location:  Hill Country, TX

    Posts:    1,578

    My VIN:    Formerly 2329

    Just got my EFI analytics package today with my Bluetooth serial adapter. I have now ditched the cable in the car and can wander around as I tune the car..... sometimes this tech stuff is just too cool. I'm now able to use the MSDroid app on my cell phone too, so if I just want to grab a log or watch the gauges I don't even need my netbook, just the android.
    Owen
    I.Brew.Beer.

Page 2 of 2 FirstFirst 1 2

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •