LOTS of Engine Parts For Sale

[ltemup4650]

Hello fellow DMCers,

I have a lot of engine parts for sale. Most of these came off of a running motor with bad cylinder liners. I replaced the motor with a B28F out of a volvo and have a lot of extra parts.

I live in Bloomington, IL
You can contact me at: [email protected]
Prices I believe are fair (25% to 75% below new) and most are negotiable.

Block (upper crankcase-cylinder liners removed) Part #:102001 $400

Crankshaft (will come with timing and oil pump sprockets. Will need machined/turned) $300
Crankshaft pulley nut. Part #:102474 $10
Pistons and connecting rods (6) (NOTE: pistons are probably NOT good, but the connecting rods are). $50 each connecting rod (will come with a piston)
Head (rebuilt, only 200 miles. Off running motor) 4,5,6 (loaded with valves) Part #:102157 $400
Head (rebuilt, only 200 miles. Off running motor) 1,2,3 (loaded with valves) Part #:102173 $400
Cam Shaft 1,2,3 (Passenger) Part #:102707 $100
Cam Shaft 4,5,6 (Driver) Part #:102706 $100
Rocker Arm Assembly (1,2,3) $150
Rocker Arm Assembly (4,5,6) $150
Timing Chain 1,2,3 Part #:102214 $10
Timing Chain 4,5,6 Part #:102214 $10
Timing Sprocket 1,2,3 Part #: 102209 $20
Timing Sprocket 4,5,6 Part #: 102209 $20
Timing chain tensioner kit 1,2,3 Part #:102605 $75
Timing chain tensioner kit 4,5,6 Part #:102605 $75
Oil pump and sprocket Part #:102622 $100
Oil pump drive chain Part #:102229 $30
Driver side valve cover Part #:102252 $75
Timing cover Part #:102192 $100
Intake Part #:102260 $200
Tubes, throttle/manifold (Bull horns) Part #:102279 $150
Mixture control unit Part #:102789 $200
Mixture control lower housing Part #:102771 -- (NOTE, This unit has a modification where the idle air motor tube goes. It is probably a better than stock design, but still not stock. It has a welded nipple so you can slide the air hose right on. I can take a picture if you want). $75


Throttle Butterfly assembly Part #:102856 $40
Fuel Distributor Part #:102807 $200
Ignition distributor Part #:102751 -- (some of the plastic on the plug is gone, but it still plugs in and works. It came off a running motor). $150

Idle air motor (untested) Part #:102502 $100
Fuel injectors (I have 12) Part #:102742 $25 each
Cold start tube Part #:102374 $40
Cold Start Injector Part #:102372 $50
Rear main seal housing. Part #:102023 $30
Warm up regulator (untested) Part #:102353 $60
Exhuast Manifold 1,2,3 Part #:102258 $150
Exhaust Manifold 4,5,6 Part #:102257 $150

[Spittybug]

As a magnanimous gesture, what about a consignment "loan" to AdmiralSenn (Adam) of a head so that he can get his car sold in running condition? I'm not brokering this, merely suggesting there may be some goodwill to be extended until he can sell the car..................... just an idea.

[thirdmanj]

As a magnanimous gesture, what about a consignment "loan" to AdmiralSenn (Adam) of a head so that he can get his car sold in running condition? I'm not brokering this, merely suggesting there may be some goodwill to be extended until he can sell the car..................... just an idea.

Hear hear!!

[Ron]

Looks like you may have 90% of the fasteners etc I need if you are going to break it all up.
http://dmctalk.org/showthread.php?4534-Misc-Banjo-Bolts-Fuel-Fittings PM me...

[ltemup4650]

Spittybug...perhaps I will message AdmiralSenn.

As a magnanimous gesture, what about a consignment "loan" to AdmiralSenn (Adam) of a head so that he can get his car sold in running condition? I'm not brokering this, merely suggesting there may be some goodwill to be extended until he can sell the car..................... just an idea.

[seventy4burban]

You don't have an oil pan by chance do you. I am in serious need!

[ltemup4650]

I don't have an oil pan. sorry!

You don't have an oil pan by chance do you. I am in serious need!

[ltemup4650]

Bumping post. Cam Shafts and Warm Up Regulator are sold.

Hello fellow DMCers,

I have a lot of engine parts for sale. Most of these came off of a running motor with bad cylinder liners. I replaced the motor with a B28F out of a volvo and have a lot of extra parts.

I live in Bloomington, IL
You can contact me at: [email protected]
Prices I believe are fair (25% to 75% below new) and most are negotiable.

Block (upper crankcase-cylinder liners removed) Part #:102001 $400
Crankshaft (will come with timing and oil pump sprockets. Will need machined/turned) $300
Crankshaft pulley nut. Part #:102474 $10
Pistons and connecting rods (6) (NOTE: pistons are probably NOT good, but the connecting rods are). $50 each connecting rod (will come with a piston)
Head (rebuilt, only 200 miles. Off running motor) 4,5,6 (loaded with valves) Part #:102157 $400
Head (rebuilt, only 200 miles. Off running motor) 1,2,3 (loaded with valves) Part #:102173 $400
Rocker Arm Assembly (1,2,3) $150
Rocker Arm Assembly (4,5,6) $150
Timing Chain 1,2,3 Part #:102214 $10
Timing Chain 4,5,6 Part #:102214 $10
Timing Sprocket 1,2,3 Part #: 102209 $20
Timing Sprocket 4,5,6 Part #: 102209 $20
Timing chain tensioner kit 1,2,3 Part #:102605 $75
Timing chain tensioner kit 4,5,6 Part #:102605 $75
Oil pump and sprocket Part #:102622 $100
Oil pump drive chain Part #:102229 $30
Driver side valve cover Part #:102252 $75
Timing cover Part #:102192 $100
Intake Part #:102260 $200
Tubes, throttle/manifold (Bull horns) Part #:102279 $150
Mixture control unit Part #:102789 $200
Mixture control lower housing Part #:102771 -- (NOTE, This unit has a modification where the idle air motor tube goes. It is probably a better than stock design, but still not stock. It has a welded nipple so you can slide the air hose right on. I can take a picture if you want). $75


Throttle Butterfly assembly Part #:102856 $40
Fuel Distributor Part #:102807 $200
Ignition distributor Part #:102751 -- (some of the plastic on the plug is gone, but it still plugs in and works. It came off a running motor). $150

Idle air motor (untested) Part #:102502 $100
Fuel injectors (I have 12) Part #:102742 $25 each
Cold start tube Part #:102374 $40
Cold Start Injector Part #:102372 $50
Rear main seal housing. Part #:102023 $30
Exhuast Manifold 1,2,3 Part #:102258 $150
Exhaust Manifold 4,5,6 Part #:102257 $150

[AugustneverEnds]

Hi, you wouldn't happen to have the gaskets and studs with the exhaust manifolds by any chance?

[ltemup4650]

I have the studs but no gaskets...why would you want used gaskets? These are cheap from part stores. Look them up on Rockauto.com $22 per side.

BECK/ARNLEY Part # 0374630

Use 1983 Volvo 760 with 2.8 as a search vehicle.

Hi, you wouldn't happen to have the gaskets and studs with the exhaust manifolds by any chance?