These are the ground junctions that also need to be tied into a bus:
Near the rear bulkhead connectors:
GroundBusBulkheadConnectors.jpg
Bulkhead bolt itself:
GroundBusBulkheadBolt.jpg
One inside the relay compartment:
GroundBusRelayCompartment.jpg
Under the console in the rear (driver's side):
GroundBusConsoleRear.jpg
Under the console, in the middle (passenger side):
GroundBusConsoleMiddle.jpg
Under the console, in the front (very close to the radio bracket):
GroundBusConsoleFront.jpg
I mounted a block with a 1/4" stud in the ECU compartment to easily add new grounds, or anything I've overlooked, in the back of the car (I also have a bolt in the relay compartment, but it's 3/8" diameter -- I just use the metal superstructure, to which that bolt is attached, as a block for relays, etc).
Former radio bracket grounds are attached to the bus with a 1/4" nut & bolt. Any new grounds or anything I've overlooked in the front of the car (I am debating whether to run a new wire to the dashboard bolt by the glove box -- doesn't seem necessary at this time) can be added to the bus there.
Bill Robertson
#5939


Reply With Quote

