FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com
Results 1 to 1 of 1

Thread: Stuck gauges at 6:00 or 12:00

  1. #1
    Senior Member Bitsyncmaster's Avatar
    Join Date:  May 2011

    Location:  Leonardtown, MD

    Posts:    9,638

    My VIN:    03572

    Stuck gauges at 6:00 or 12:00

    If you have been following some recent posts the problem of stuck gauges which require vibration to get them unstuck has come up again.

    When I first designed my fuel gauge ECU I bought a spare set of gauges to use for testing and calibration. The new gauge would move very slowly from any large sensor change. After many hours of my use of this new gauge one day it seemed to loose all that slow movement and now responds instantly. The calibration did not change just the speed of the movement. I can peg that gauge at 12:00 or 6:00 and it never sticks. What I did today was look very closely at the needle and if I move the pointer to either 12:00 or 6:00 and drive it full (83 ohms) or empty (6 ohms) I can see the needle does overshoot to about the 12:00 or 6:00 position. I would need to do a fast video and slow it down to see the exact overshoot.

    I'm guessing if that slow movement is only working a little it is the cause of the sticking needle. It must be mass of the needle and it's magnet causing the overshoot.

    I was just thinking if there was anything I could do with my ECU to help or prevent this problem. Maybe set half full on the gauge before moving to the true sensor reading. That would reduce some of the momentum.
    Last edited by Bitsyncmaster; Today at 04:32 PM.
    Dave M vin 03572
    http://dm-eng.weebly.com/

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •