FRAMING JOHN DELOREAN - ON VOD
www.framingjohndeloreanfilm.com
-
If the harness changed, if was after VIN 5939 (both of my cars have a junction behind the central A/C duct).
I never paid too much attention to that bundle of wires on the radio bracket until this project. Both #2508 and #5939 have nothing but capacitors and the radio on it.
I suspect people assumed the instrument cluster was grounded to the radio bracket because the ground junction behind the central A/C duct is virtually impossible to see. I had no idea it was back there. When I tied #5939's junction into its ground bus I had to do all the work by braille -- that's how hidden it is. There are only 3 ground wires coming down the driver's side of the console, so the binnacle was obviously grounded somewhere north of the radio bracket. I guess people just assumed that one of those wires had to be it (two wires actually -- there are two grounds from the binnacle/instrument cluster).
I am open to changing the schematic, but only if the changes are proven by visual inspection. I ripped all the wrapping off #2508's harness to make it. Nearly every single wire was individually traced. There are only a couple of assumptions in the current revision:
- Individual ground wire that disappears into the dash by the passenger windshield corner (not the A pillar bundle) is assumed to the the same wire that emerges from underneath the exterior trim piece and is bolted to the fender
- Third large gauge wire leaving the junction behind the central A/C duct is assumed to be the windshield wiper motor. I have yet to find the motor to verify that it does indeed have a large gauge wire attached to it (where is the damn thing?)
- Every small wire leaving the junction behind the central A/C duct is accounted for. There is a ganged small gauge wire leaving the plate that holds the windshield wiper delay module going somewhere.
The wiring harness up & over the steering column is the only one I did not unwrap, because it is sandwiched between the metal superstructure and the dash (inaccessible). I did unwrap the harness where it passes through the firewall towards the windshield washer bottle -- there are only two large gauge ground wires in it at that point.
Believe it or not, I traced every inch of the two black wires from the Lambda ECU to the bulkhead connectors, including unwrapping the bundles all the way through the plywood bulkhead (twice!). That's no small feat. I had to do it -- those wires were obviously present in different locations but unaccounted for. I physically followed each wire to see where they went. I have no idea what they do, or even if they are in fact grounds, but that is definitely where they go (verified this morning by ringing them out with a meter).
The cigarette lighter ground is a tricky one. The wire starts towards the front of the car, then about 4-6 inches later makes a U turn back to the harness that goes to the rocker switches. Unless you unwrap the entire harness it looks like two different wires.
Bill Robertson
#5939

Originally Posted by
sean
Ok, Bill, the one you have uploaded seem proper to me as when I upload this guy I can click on him and he expands. Does this not work for others? You actually have to click on him twice to make it expand.
DeLoreanGroundsFinal3.jpg
Still 840x1030.
This is what my 1300x1595 working copy looks like split down the middle:
DeLoreanGroundsFinal4Left.jpgDeLoreanGroundsFinal4Right.jpg
Bill Robertson
#5939
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules