FRAMING JOHN DELOREAN - ON VOD
www.framingjohndeloreanfilm.com
-
Administrator

Originally Posted by
Farrar
Isn't that dangerous? I have a 45,000-volt ignition coil. I don't want to electrocute myself tomorrow morning.
If you pull the wire from the plug end, just don't yank it out of the cavity and the spark will jump to the block. If you pull it from the cap end, you will be holding a dead wire, assuming it and another one is not old, has a bad spots, etc that will allow the spark to cross over, in which case you will be alerted to the problem instantly ;-) -- Just don't grab it right near the end. There are several tongs and such you can get cheap, if you are that worried about it. (BTW, it's not high voltage that gives you a heart attack, it is LOW amps (< 1A !!!) through the heart ...it's not good for bone marrow in your fingers though ;-)

Originally Posted by
Farrar
I thought if you closed the choke at idle the engine would die because it can't breathe. Do I have this backwards?
No you're right idle or not, unless you have a HUGE leak. But I said "sloooooowly". The idea is that an air leak will make it run lean. As you slowly close the choke there must be a place between lean and choked out that the air is right. When you approach it, the sound of the engine will let you know. Ideally you should do this before you change anything, particularly air or fuel screws. And it may not work well depending on where air is getting in.
(If it is small and only affecting one cylinder/runner, you probably won't catch it -- but pulling its plug should -- a fair leak, like the rear of the carb gasket, internal crack, etc. can affect all cylinders and will act like the choke is opened too far (on a cool-warm engine) and hard to miss. It's just a tool.

Originally Posted by
Farrar
Once upon a time, I used to use the vacuum gauge to adjust the carburetor; I would simply idle the engine and adjust the air mixture screws until the vacuum reading was highest. Boy, those were the days.
yep...it has better ears than you or I.
"were"? Why did you quit?... Google "Autolite 2100 vacuum gauge"
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules